FaultCodes.org
P0702OBD-IITransmission & DrivetrainTechnical Reference· Updated: Nov 22, 2026

P0702 Fault Code: Transmission Control System Electrical

OBD-II P0702 (Transmission & Drivetrain): Transmission Control System Electrical.

Quick AnswerHigh — Service Soon

OBD-II fault code P0702 indicates Transmission Control System Electrical. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $54–$1296.

Safe to Operate?
No — Risk of Damage
DIY Difficulty
Moderate (Intermediate)
System
Transmission & Drivetrain
Professional Repair
$54 – $1,296

What This Fault Code Means

P0702 reports an electrical fault in the transmission control system as a whole – typically the supply of the transmission actuators (solenoid supply, transmission relay, supply switch in the module) or a circuit fault not assigned to a single component. No manufacturer document available to us describes it in detail; Ford's engine module list for 6.8 L E- and F-Series trucks stores it without the check engine light. If the solenoid supply is lost, transmissions usually fall back to a hydraulic limp gear. Individual solenoids have their own codes (P0750 ff); actuator supply is P0657 ff.

Common Symptoms

  • Transmission limp mode with fixed gear
  • Transmission warning; check engine light depending on the maker
  • No or harsh shifts, further solenoid codes

Most Likely Root Causes

  • Transmission actuator supply interrupted (fuse, relay, ground)
  • Harness or connector at transmission or module damaged, corroded or oil-soaked
  • Transmission module output stage or supply switch faulty
  • Low or fluctuating system voltage

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside P0702.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Transmission Control Module.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside P0702?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Transmission Control Module.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Transmission Control Module.
  5. 5Clear fault memory and run a verification cycle to confirm P0702 does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$19 – $544
Professional Repair (Parts + Labor)$54 – $1,296

Frequently Asked Questions

Is it safe to keep operating with fault code P0702?

Avoid prolonged operation until inspected to prevent secondary component damage.

How much does it cost to repair P0702?

DIY replacement parts average $19–$544, while professional service averages $54–$1296.

Will resetting P0702 fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

P0702 fault code meaningP0702 repair costhow to fix P0702

Manufacturer & Technical Reference

OBD-II Technical Reference (Transmission & Drivetrain)

Related Fault Codes

Auto & OBD-II →
P0702 Fault Code: Transmission Control System Electrical | FaultCodes.org