# OBD-II P0702: Transmission Control System Electrical

> **Quick Answer:** OBD-II fault code P0702 indicates Transmission Control System Electrical. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $54–$1296.

- **URL:** https://faultcodes.org/automotive/obd2-p0702
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Transmission & Drivetrain
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
P0702 reports an electrical fault in the transmission control system as a whole – typically the supply of the transmission actuators (solenoid supply, transmission relay, supply switch in the module) or a circuit fault not assigned to a single component. No manufacturer document available to us describes it in detail; Ford's engine module list for 6.8 L E- and F-Series trucks stores it without the check engine light. If the solenoid supply is lost, transmissions usually fall back to a hydraulic limp gear. Individual solenoids have their own codes (P0750 ff); actuator supply is P0657 ff.

## Common Symptoms
- Transmission limp mode with fixed gear
- Transmission warning; check engine light depending on the maker
- No or harsh shifts, further solenoid codes

## Most Likely Root Causes
- Transmission actuator supply interrupted (fuse, relay, ground)
- Harness or connector at transmission or module damaged, corroded or oil-soaked
- Transmission module output stage or supply switch faulty
- Low or fluctuating system voltage

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Transmission Control Module.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Transmission Control Module.
5. Clear fault memory and run a verification cycle to confirm P0702 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$544 | $54–$1296 |
| GBP | £15–£428 | £43–£1032 |
| CAD | CA$26–CA$731 | CA$73–CA$1740 |
| EUR | €18–€504 | €50–€1200 |
| CHF | CHF 21–CHF 580 | CHF 66–CHF 1584 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0702?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0702?
DIY replacement parts average $19–$544, while professional service averages $54–$1296.

### Will resetting P0702 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

