P0314 Fault Code: Single Cylinder Misfire (Cylinder Not Specified)
OBD-II P0314 (Ignition & Misfire System): Single Cylinder Misfire (Cylinder Not Specified).
OBD-II fault code P0314 indicates Single Cylinder Misfire (Cylinder Not Specified). Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$1620.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Professional Recommended
- System
- Ignition & Misfire System
- Professional Repair
- $86 – $1,620
What This Fault Code Means
P0314 means the misfire is attributable to a single cylinder, but the module does not say which one. CARB generally requires cylinder-specific codes and allows a general code only with approval where the cylinder cannot be identified reliably; for diesels identification is required only where possible without extra hardware. GM and Ford do not use P0314. It is documented on Saab's 2.2 TiD diesel with a Bosch distributor pump, as a mechanical misfire fault in two speed and quantity windows with the warning light and limp mode limiting injection quantity; the cylinder can still be read out with a scan tool. Typical causes are a faulty injector, leaking high-pressure lines, air or water in the fuel, or low compression.
Common Symptoms
- Check engine light on
- Loss of power, limp mode with quantity limit (Saab diesel)
- Rough running, vibration
Most Likely Root Causes
- Injector of one cylinder clogged or leaking (diesel), or coil/plug (petrol)
- Leaking high-pressure line, fuel bridge or injector washer
- Air, water or petrol in the diesel, clogged filter, low supply pressure
- Compression loss (valve, piston)
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside P0314.
- 2Inspect electrical connectors, fuses, and harnesses connected to Fuel Injectors.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside P0314?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Fuel Injectors.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Fuel Injectors.
- 5Clear fault memory and run a verification cycle to confirm P0314 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $30 – $680 |
| Professional Repair (Parts + Labor) | $86 – $1,620 |
Certified Technician Service Checklist
This fault involves sealed safety, gas, or high-voltage systems. Share these details when requesting a repair quote.
- Share exact brand & fault code: P0314 (Ignition & Misfire System)
- Record appliance/boiler serial, model plate, or pressure reading before calling
- Typical certified technician range: $86 – $1,620
Frequently Asked Questions
Is it safe to keep operating with fault code P0314?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair P0314?
DIY replacement parts average $30–$680, while professional service averages $86–$1620.
Will resetting P0314 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Ignition & Misfire System)