# OBD-II P0314: Single Cylinder Misfire (Cylinder Not Specified)

> **Quick Answer:** OBD-II fault code P0314 indicates Single Cylinder Misfire (Cylinder Not Specified). Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$1620.

- **URL:** https://faultcodes.org/automotive/obd2-p0314
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Ignition & Misfire System
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
P0314 means the misfire is attributable to a single cylinder, but the module does not say which one. CARB generally requires cylinder-specific codes and allows a general code only with approval where the cylinder cannot be identified reliably; for diesels identification is required only where possible without extra hardware. GM and Ford do not use P0314. It is documented on Saab's 2.2 TiD diesel with a Bosch distributor pump, as a mechanical misfire fault in two speed and quantity windows with the warning light and limp mode limiting injection quantity; the cylinder can still be read out with a scan tool. Typical causes are a faulty injector, leaking high-pressure lines, air or water in the fuel, or low compression.

## Common Symptoms
- Check engine light on
- Loss of power, limp mode with quantity limit (Saab diesel)
- Rough running, vibration

## Most Likely Root Causes
- Injector of one cylinder clogged or leaking (diesel), or coil/plug (petrol)
- Leaking high-pressure line, fuel bridge or injector washer
- Air, water or petrol in the diesel, clogged filter, low supply pressure
- Compression loss (valve, piston)

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Fuel Injectors.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Fuel Injectors.
5. Clear fault memory and run a verification cycle to confirm P0314 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$680 | $86–$1620 |
| GBP | £24–£536 | £69–£1290 |
| CAD | CA$41–CA$914 | CA$116–CA$2175 |
| EUR | €28–€630 | €80–€1500 |
| CHF | CHF 32–CHF 725 | CHF 106–CHF 1980 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0314?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0314?
DIY replacement parts average $30–$680, while professional service averages $86–$1620.

### Will resetting P0314 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

