FaultCodes.org
P0117OBD-IIEngine Cooling & ThermostatTechnical Reference· Updated: Nov 22, 2026

P0117 Fault Code: Engine Coolant Temperature Sensor 1 Circuit Low

OBD-II P0117 (Engine Cooling & Thermostat): Engine Coolant Temperature Sensor 1 Circuit Low.

Quick AnswerHigh — Service Soon

OBD-II fault code P0117 indicates Engine Coolant Temperature Sensor 1 Circuit Low. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$162.

Safe to Operate?
No — Risk of Damage
DIY Difficulty
Easy (Basic Tools)
System
Engine Cooling & Thermostat
Professional Repair
$43 – $162

What This Fault Code Means

The engine coolant temperature sensor 1 is an NTC thermistor: the control module feeds 5 V through a resistor, and as the coolant warms the resistance and signal voltage fall. Its value drives cold-start enrichment, idle speed, ignition timing, the radiator fan and the release of closed-loop mixture control. Some Ford engines measure cylinder head temperature instead and calculate a coolant value from it. P0117 means the signal voltage is too low, so the sensor would report an implausibly hot engine (around 140–160 °C). Usual causes are a signal wire shorted to ground, coolant or moisture in the connector, or an internally shorted sensor. Limits: GM below 55 ohms, Ford petrol below 0.244 V for 5 s, Ford diesel below 0.10 V, Mitsubishi below 0.1 V for 2 s. Mitsubishi then calculates with 80 °C; GM/Saab switch the radiator fan on and the A/C compressor off. GM needs two trips. On Ford engines with a head temperature sensor the equivalent is P1290.

Common Symptoms

  • Check engine light on
  • Radiator fan runs constantly
  • Hard cold start (no enrichment, engine reported hot)
  • Temperature gauge at hot end
  • A/C may be switched off

Most Likely Root Causes

  • Signal wire shorted to ground (chafing, pinched harness)
  • Sensor shorted internally or coolant inside the sensor
  • Moisture or coolant in the connector
  • Engine control module faulty

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside P0117.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Engine Coolant Temperature Sensor.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside P0117?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Engine Coolant Temperature Sensor.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Engine Coolant Temperature Sensor.
  5. 5Clear fault memory and run a verification cycle to confirm P0117 does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$16 – $68
Professional Repair (Parts + Labor)$43 – $162

Frequently Asked Questions

Is it safe to keep operating with fault code P0117?

Avoid prolonged operation until inspected to prevent secondary component damage.

How much does it cost to repair P0117?

DIY replacement parts average $16–$68, while professional service averages $43–$162.

Will resetting P0117 fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

P0117 fault code meaningP0117 repair costhow to fix P0117

Manufacturer & Technical Reference

OBD-II Technical Reference (Engine Cooling & Thermostat)

Related Fault Codes

Auto & OBD-II →
P0117 Fault Code: Engine Coolant Temperature Sensor 1 Circuit Low | FaultCodes.org