# OBD-II P0117: Engine Coolant Temperature Sensor 1 Circuit Low

> **Quick Answer:** OBD-II fault code P0117 indicates Engine Coolant Temperature Sensor 1 Circuit Low. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$162.

- **URL:** https://faultcodes.org/automotive/obd2-p0117
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The engine coolant temperature sensor 1 is an NTC thermistor: the control module feeds 5 V through a resistor, and as the coolant warms the resistance and signal voltage fall. Its value drives cold-start enrichment, idle speed, ignition timing, the radiator fan and the release of closed-loop mixture control. Some Ford engines measure cylinder head temperature instead and calculate a coolant value from it. P0117 means the signal voltage is too low, so the sensor would report an implausibly hot engine (around 140–160 °C). Usual causes are a signal wire shorted to ground, coolant or moisture in the connector, or an internally shorted sensor. Limits: GM below 55 ohms, Ford petrol below 0.244 V for 5 s, Ford diesel below 0.10 V, Mitsubishi below 0.1 V for 2 s. Mitsubishi then calculates with 80 °C; GM/Saab switch the radiator fan on and the A/C compressor off. GM needs two trips. On Ford engines with a head temperature sensor the equivalent is P1290.

## Common Symptoms
- Check engine light on
- Radiator fan runs constantly
- Hard cold start (no enrichment, engine reported hot)
- Temperature gauge at hot end
- A/C may be switched off

## Most Likely Root Causes
- Signal wire shorted to ground (chafing, pinched harness)
- Sensor shorted internally or coolant inside the sensor
- Moisture or coolant in the connector
- Engine control module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Engine Coolant Temperature Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Engine Coolant Temperature Sensor.
5. Clear fault memory and run a verification cycle to confirm P0117 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$68 | $43–$162 |
| GBP | £13–£54 | £34–£129 |
| CAD | CA$22–CA$91 | CA$58–CA$218 |
| EUR | €15–€63 | €40–€150 |
| CHF | CHF 17–CHF 72 | CHF 53–CHF 198 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0117?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0117?
DIY replacement parts average $16–$68, while professional service averages $43–$162.

### Will resetting P0117 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

