FaultCodes.org
P0115OBD-IIEngine Cooling & ThermostatTechnical Reference· Updated: Nov 22, 2026

P0115 Fault Code: Engine Coolant Temperature Sensor 1 Circuit

OBD-II P0115 (Engine Cooling & Thermostat): Engine Coolant Temperature Sensor 1 Circuit.

Quick AnswerHigh — Service Soon

OBD-II fault code P0115 indicates Engine Coolant Temperature Sensor 1 Circuit. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$162.

Safe to Operate?
No — Risk of Damage
DIY Difficulty
Easy (Basic Tools)
System
Engine Cooling & Thermostat
Professional Repair
$43 – $162

What This Fault Code Means

The engine coolant temperature sensor 1 is an NTC thermistor: the control module feeds 5 V through a resistor, and as the coolant warms the resistance and signal voltage fall. Its value drives cold-start enrichment, idle speed, ignition timing, the radiator fan and the release of closed-loop mixture control. Some Ford engines measure cylinder head temperature instead and calculate a coolant value from it. P0115 is the general circuit fault without telling low from high. Today it has largely been replaced by P0117, P0118 and P0119; GM and Ford do not set it in the tables checked. Older or individual systems still use it as a collective code, for example Saab Trionic T5 (1998). The circuit is monitored continuously; when it fails, the module uses a substitute value and many systems run the radiator fan permanently.

Common Symptoms

  • Check engine light on
  • Poor cold or hot starting
  • Radiator fan runs constantly
  • Higher consumption, rough idle
  • Temperature gauge implausible or dead

Most Likely Root Causes

  • Connector corroded or loose, terminal spread
  • Broken or chafed signal or ground wire
  • Sensor faulty internally (short, open, coolant inside)
  • Control module input or 5 V supply faulty

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside P0115.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Engine Coolant Temperature Sensor.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside P0115?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Engine Coolant Temperature Sensor.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Engine Coolant Temperature Sensor.
  5. 5Clear fault memory and run a verification cycle to confirm P0115 does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$16 – $68
Professional Repair (Parts + Labor)$43 – $162

Frequently Asked Questions

Is it safe to keep operating with fault code P0115?

Avoid prolonged operation until inspected to prevent secondary component damage.

How much does it cost to repair P0115?

DIY replacement parts average $16–$68, while professional service averages $43–$162.

Will resetting P0115 fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

P0115 fault code meaningP0115 repair costhow to fix P0115

Manufacturer & Technical Reference

OBD-II Technical Reference (Engine Cooling & Thermostat)

Related Fault Codes

Auto & OBD-II →
P0115 Fault Code: Engine Coolant Temperature Sensor 1 Circuit | FaultCodes.org