# OBD-II P0115: Engine Coolant Temperature Sensor 1 Circuit

> **Quick Answer:** OBD-II fault code P0115 indicates Engine Coolant Temperature Sensor 1 Circuit. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$162.

- **URL:** https://faultcodes.org/automotive/obd2-p0115
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The engine coolant temperature sensor 1 is an NTC thermistor: the control module feeds 5 V through a resistor, and as the coolant warms the resistance and signal voltage fall. Its value drives cold-start enrichment, idle speed, ignition timing, the radiator fan and the release of closed-loop mixture control. Some Ford engines measure cylinder head temperature instead and calculate a coolant value from it. P0115 is the general circuit fault without telling low from high. Today it has largely been replaced by P0117, P0118 and P0119; GM and Ford do not set it in the tables checked. Older or individual systems still use it as a collective code, for example Saab Trionic T5 (1998). The circuit is monitored continuously; when it fails, the module uses a substitute value and many systems run the radiator fan permanently.

## Common Symptoms
- Check engine light on
- Poor cold or hot starting
- Radiator fan runs constantly
- Higher consumption, rough idle
- Temperature gauge implausible or dead

## Most Likely Root Causes
- Connector corroded or loose, terminal spread
- Broken or chafed signal or ground wire
- Sensor faulty internally (short, open, coolant inside)
- Control module input or 5 V supply faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Engine Coolant Temperature Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Engine Coolant Temperature Sensor.
5. Clear fault memory and run a verification cycle to confirm P0115 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$68 | $43–$162 |
| GBP | £13–£54 | £34–£129 |
| CAD | CA$22–CA$91 | CA$58–CA$218 |
| EUR | €15–€63 | €40–€150 |
| CHF | CHF 17–CHF 72 | CHF 53–CHF 198 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0115?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0115?
DIY replacement parts average $16–$68, while professional service averages $43–$162.

### Will resetting P0115 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

