C0044 Fault Code: Brake Pressure Sensor A
OBD-II C0044 (Chassis, ABS & Stability Control): Brake Pressure Sensor A.
OBD-II fault code C0044 indicates Brake Pressure Sensor A. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $432–$2376.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Professional Recommended
- System
- Chassis, ABS & Stability Control
- Professional Repair
- $432 – $2,376
What This Fault Code Means
Covers brake pressure sensor A (sensor 1) in the ABS/ESC hydraulic unit, which measures master-cylinder or circuit brake pressure. The stability and brake modules use this reading to know how hard the driver is braking and to control traction, stability, brake assist and hill-hold. The module sets the code for a signal outside the valid range, an open or short, or a value that disagrees with pedal demand or a second pressure sensor. RAM assigns code C0044-01 to a general electrical failure of brake pressure sensor 1 on the 2024 2500; because the transducer sits inside the hydraulic control unit, the published repair replaces the whole integrated brake unit. A fault disables stability and assist functions and sets the ABS or brake warning lamp.
Common Symptoms
- ABS or brake warning lamp on
- Stability and assist functions disabled
- Changed brake assist behaviour
Most Likely Root Causes
- Pressure sensor failed or out of range
- Fault internal to the integrated brake unit
- Harness or connector fault
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside C0044.
- 2Inspect electrical connectors, fuses, and harnesses connected to Brake Pressure Sensor A.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside C0044?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Brake Pressure Sensor A.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Brake Pressure Sensor A.
- 5Clear fault memory and run a verification cycle to confirm C0044 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $151 – $998 |
| Professional Repair (Parts + Labor) | $432 – $2,376 |
Certified Technician Service Checklist
This fault involves sealed safety, gas, or high-voltage systems. Share these details when requesting a repair quote.
- Share exact brand & fault code: C0044 (Chassis, ABS & Stability Control)
- Record appliance/boiler serial, model plate, or pressure reading before calling
- Typical certified technician range: $432 – $2,376
Frequently Asked Questions
Is it safe to keep operating with fault code C0044?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair C0044?
DIY replacement parts average $151–$998, while professional service averages $432–$2376.
Will resetting C0044 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Chassis, ABS & Stability Control)