FaultCodes.org
C003EOBD-IIChassis, ABS & Stability ControlTechnical Reference· Updated: Nov 22, 2026

C003E Fault Code: Rear Wheel Speed Sensor Supply

OBD-II C003E (Chassis, ABS & Stability Control): Rear Wheel Speed Sensor Supply.

Quick AnswerHigh — Service Soon

OBD-II fault code C003E indicates Rear Wheel Speed Sensor Supply. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $65–$486.

Safe to Operate?
No — Risk of Damage
DIY Difficulty
Moderate (Intermediate)
System
Chassis, ABS & Stability Control
Professional Repair
$65 – $486

What This Fault Code Means

Covers the supply circuit that powers a single rear active wheel speed sensor on vehicles with one combined rear speed signal. Active sensors need a regulated voltage from the ABS/ESC module; this code is set when that supply is open, shorted to ground or another voltage, or outside the regulated range so the sensor cannot produce a valid signal. It is distinct from the sensor-signal code C003D in that the fault is on the feed rather than the sensor element. A fault disables ABS, traction and stability control and lights the ABS warning lamp while base braking remains. No manufacturer documents this code publicly; the J2012 table in NHTSA's EPS safety report lists C003E as the rear sensor supply.

Common Symptoms

  • ABS warning lamp on
  • ABS and stability control disabled
  • No rear wheel speed signal

Most Likely Root Causes

  • Open or shorted sensor supply wire
  • Corroded connector on the supply side
  • Module sensor supply output fault

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside C003E.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Rear Wss.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside C003E?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Rear Wss.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Rear Wss.
  5. 5Clear fault memory and run a verification cycle to confirm C003E does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$23 – $204
Professional Repair (Parts + Labor)$65 – $486

Frequently Asked Questions

Is it safe to keep operating with fault code C003E?

Avoid prolonged operation until inspected to prevent secondary component damage.

How much does it cost to repair C003E?

DIY replacement parts average $23–$204, while professional service averages $65–$486.

Will resetting C003E fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

C003E fault code meaningC003E repair costhow to fix C003E

Manufacturer & Technical Reference

OBD-II Technical Reference (Chassis, ABS & Stability Control)

Related Fault Codes

Auto & OBD-II →
C003E Fault Code: Rear Wheel Speed Sensor Supply — Fixes & Cost | FaultCodes.org