# OBD-II C003E: Rear Wheel Speed Sensor Supply

> **Quick Answer:** OBD-II fault code C003E indicates Rear Wheel Speed Sensor Supply. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $65–$486.

- **URL:** https://faultcodes.org/automotive/obd2-c003e
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Chassis, ABS & Stability Control
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Covers the supply circuit that powers a single rear active wheel speed sensor on vehicles with one combined rear speed signal. Active sensors need a regulated voltage from the ABS/ESC module; this code is set when that supply is open, shorted to ground or another voltage, or outside the regulated range so the sensor cannot produce a valid signal. It is distinct from the sensor-signal code C003D in that the fault is on the feed rather than the sensor element. A fault disables ABS, traction and stability control and lights the ABS warning lamp while base braking remains. No manufacturer documents this code publicly; the J2012 table in NHTSA's EPS safety report lists C003E as the rear sensor supply.

## Common Symptoms
- ABS warning lamp on
- ABS and stability control disabled
- No rear wheel speed signal

## Most Likely Root Causes
- Open or shorted sensor supply wire
- Corroded connector on the supply side
- Module sensor supply output fault

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Rear Wss.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Rear Wss.
5. Clear fault memory and run a verification cycle to confirm C003E does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$204 | $65–$486 |
| GBP | £18–£161 | £52–£387 |
| CAD | CA$30–CA$274 | CA$87–CA$653 |
| EUR | €21–€189 | €60–€450 |
| CHF | CHF 24–CHF 217 | CHF 79–CHF 594 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code C003E?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair C003E?
DIY replacement parts average $23–$204, while professional service averages $65–$486.

### Will resetting C003E fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

