C001E Fault Code: Right Rear Hydraulic Release Too Long
OBD-II C001E (Chassis, ABS & Stability Control): Right Rear Hydraulic Release Too Long.
OBD-II fault code C001E indicates Right Rear Hydraulic Release Too Long. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $324–$1944.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Professional Recommended
- System
- Chassis, ABS & Stability Control
- Professional Repair
- $324 – $1,944
What This Fault Code Means
Set when the ABS modulator cannot release pressure at the right rear wheel within the expected time during a control cycle, completing the per-wheel set with C0012, C0016 and C001A. After commanding the right rear outlet valve to dump pressure the module expects wheel speed to recover and line pressure to fall; a release longer than the calibrated limit points to a sticking valve, a restricted hydraulic path or an accumulator or pump that cannot accept fluid. ABS and stability control are disabled and the ABS warning lamp is set. No manufacturer documents this code publicly; the release phase is covered by NHTSA's brake study, the accumulator limit by a patent on low-pressure accumulators.
Common Symptoms
- ABS warning lamp on
- ABS and stability control disabled
- Extended or firm pedal during hard braking
Most Likely Root Causes
- Outlet valve sticking or slow
- Restricted hydraulic path or contaminated fluid
- Pump or accumulator cannot accept fluid
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside C001E.
- 2Inspect electrical connectors, fuses, and harnesses connected to Rr Abs Outlet Valve.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside C001E?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Rr Abs Outlet Valve.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Rr Abs Outlet Valve.
- 5Clear fault memory and run a verification cycle to confirm C001E does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $113 – $816 |
| Professional Repair (Parts + Labor) | $324 – $1,944 |
Certified Technician Service Checklist
This fault involves sealed safety, gas, or high-voltage systems. Share these details when requesting a repair quote.
- Share exact brand & fault code: C001E (Chassis, ABS & Stability Control)
- Record appliance/boiler serial, model plate, or pressure reading before calling
- Typical certified technician range: $324 – $1,944
Frequently Asked Questions
Is it safe to keep operating with fault code C001E?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair C001E?
DIY replacement parts average $113–$816, while professional service averages $324–$1944.
Will resetting C001E fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Chassis, ABS & Stability Control)