C001C Fault Code: Right Rear Inlet Control
OBD-II C001C (Chassis, ABS & Stability Control): Right Rear Inlet Control.
OBD-II fault code C001C indicates Right Rear Inlet Control. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $324–$1836.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Professional Recommended
- System
- Chassis, ABS & Stability Control
- Professional Repair
- $324 – $1,836
What This Fault Code Means
Covers the right rear inlet (apply) solenoid valve of the ABS hydraulic modulator, the right rear counterpart of C0010 and C0018. The module closes this valve to isolate the right rear brake circuit and hold wheel pressure during ABS, traction or stability control, then opens it to reapply pressure; on the rear axle the same channel often supports electronic brake-force distribution. It monitors the coil for opens, shorts to supply or ground and resistance outside the calibrated range. A confirmed electrical fault disables ABS and stability control and lights the ABS warning lamp while base braking remains. No manufacturer documents this code publicly; the apply valve per wheel is described by NHTSA and in a pump patent.
Common Symptoms
- ABS warning lamp on
- ABS and stability control disabled
- Normal braking retained
Most Likely Root Causes
- Inlet valve coil open or shorted
- Harness or connector corrosion
- Internal hydraulic modulator fault
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside C001C.
- 2Inspect electrical connectors, fuses, and harnesses connected to Rr Abs Inlet Valve.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside C001C?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Rr Abs Inlet Valve.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Rr Abs Inlet Valve.
- 5Clear fault memory and run a verification cycle to confirm C001C does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $113 – $771 |
| Professional Repair (Parts + Labor) | $324 – $1,836 |
Certified Technician Service Checklist
This fault involves sealed safety, gas, or high-voltage systems. Share these details when requesting a repair quote.
- Share exact brand & fault code: C001C (Chassis, ABS & Stability Control)
- Record appliance/boiler serial, model plate, or pressure reading before calling
- Typical certified technician range: $324 – $1,836
Frequently Asked Questions
Is it safe to keep operating with fault code C001C?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair C001C?
DIY replacement parts average $113–$771, while professional service averages $324–$1836.
Will resetting C001C fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Chassis, ABS & Stability Control)