C0014 Fault Code: Right Front Inlet Control
OBD-II C0014 (Chassis, ABS & Stability Control): Right Front Inlet Control.
OBD-II fault code C0014 indicates Right Front Inlet Control. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $324–$1836.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Professional Recommended
- System
- Chassis, ABS & Stability Control
- Professional Repair
- $324 – $1,836
What This Fault Code Means
Covers the right front inlet (apply) solenoid valve of the ABS hydraulic modulator, the mirror of C0010 on the right front corner. The module closes this valve to isolate the right front brake circuit and hold wheel pressure during ABS, traction or stability control, then opens it to reapply pressure from the master cylinder or pump. It monitors the coil for opens, shorts to supply or ground and resistance outside the calibrated window. A confirmed electrical fault disables ABS and the stability functions and turns on the ABS warning lamp, with conventional foundation braking unaffected. No manufacturer documents this code publicly; NHTSA's safety study of hydraulic ABS/ESC brakes describes the hold valve used per wheel, and a pump patent shows it as a normally open apply valve.
Common Symptoms
- ABS warning lamp on
- ABS and stability control disabled
- Normal braking retained
Most Likely Root Causes
- Inlet valve coil open or shorted
- Harness or connector corrosion
- Internal hydraulic modulator fault
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside C0014.
- 2Inspect electrical connectors, fuses, and harnesses connected to Rf Abs Inlet Valve.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside C0014?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Rf Abs Inlet Valve.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Rf Abs Inlet Valve.
- 5Clear fault memory and run a verification cycle to confirm C0014 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $113 – $771 |
| Professional Repair (Parts + Labor) | $324 – $1,836 |
Certified Technician Service Checklist
This fault involves sealed safety, gas, or high-voltage systems. Share these details when requesting a repair quote.
- Share exact brand & fault code: C0014 (Chassis, ABS & Stability Control)
- Record appliance/boiler serial, model plate, or pressure reading before calling
- Typical certified technician range: $324 – $1,836
Frequently Asked Questions
Is it safe to keep operating with fault code C0014?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair C0014?
DIY replacement parts average $113–$771, while professional service averages $324–$1836.
Will resetting C0014 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Chassis, ABS & Stability Control)