U0002 Fault Code: High Speed CAN Communication Bus Performance
OBD-II U0002 (CAN Bus & Network Communication): High Speed CAN Communication Bus Performance.
OBD-II fault code U0002 indicates High Speed CAN Communication Bus Performance. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $65–$1080.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Professional Recommended
- System
- CAN Bus & Network Communication
- Professional Repair
- $65 – $1,080
What This Fault Code Means
U0002 stands for impaired rather than lost traffic on the high-speed CAN, and makers fill the slot in different ways. GM/Saab sets it when a supervised periodic message, which also tells the receiver that its sender is alive, has not shown up within the 250 ms supervision time; the receiver then carries on with a default value. FCA calls U0002 CAN C Bus Off Performance: a reflash for the 2013 Ram 2500/3500 6.7 L diesel PCM changed it from a one-trip to a two-trip MIL fault, whereas the 2024-26 Dodge Charger steering column module stores it without MIL because dips in supply voltage lasting about 40 ms trip a software bug. In contrast to U0001 the bus mostly keeps working, so complaints come and go: sporadic warnings or single functions dropping out briefly.
Common Symptoms
- Warning lamps that appear and disappear again
- Single functions briefly unavailable
- Code stored as history without a current fault
Most Likely Root Causes
- Intermittent contact at connectors or splices of the bus pair
- Module software reacting to short voltage dips (reflash available)
- Weak battery or poor ground causing brief module resets
- Electrical interference from retrofitted devices on the bus
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside U0002.
- 2Inspect electrical connectors, fuses, and harnesses connected to Can Bus Wiring.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside U0002?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Can Bus Wiring.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Can Bus Wiring.
- 5Clear fault memory and run a verification cycle to confirm U0002 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $23 – $454 |
| Professional Repair (Parts + Labor) | $65 – $1,080 |
Certified Technician Service Checklist
This fault involves sealed safety, gas, or high-voltage systems. Share these details when requesting a repair quote.
- Share exact brand & fault code: U0002 (CAN Bus & Network Communication)
- Record appliance/boiler serial, model plate, or pressure reading before calling
- Typical certified technician range: $65 – $1,080
Frequently Asked Questions
Is it safe to keep operating with fault code U0002?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair U0002?
DIY replacement parts average $23–$454, while professional service averages $65–$1080.
Will resetting U0002 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (CAN Bus & Network Communication)