P071C Fault Code: Transmission Mode Switch A Circuit High
OBD-II P071C (Transmission & Drivetrain): Transmission Mode Switch A Circuit High.
OBD-II fault code P071C indicates Transmission Mode Switch A Circuit High. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$324.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Easy (Basic Tools)
- System
- Transmission & Drivetrain
- Professional Repair
- $43 – $324
What This Fault Code Means
A transmission mode switch selects an alternative shift schedule such as sport, winter or tow/haul; J2012 does not define which button is A or B. No manufacturer document available to us uses P071A–P071F: GM monitors its analog drive mode switch under its own codes (low below 21–29 % of 5 V, high from 94 %, 200 of 250 samples, two trips), which shows how such buttons are read as coded voltages. P071C means the signal of mode switch A is above its upper limit – typically an open circuit pulled up inside the module, or a short to positive. The mode then cannot be selected. The opposite is P071B.
Common Symptoms
- Mode A cannot be selected or stays active
- Mode indicator missing or flashing
- Transmission stays on the normal shift schedule
Most Likely Root Causes
- Wire or connector to the button open
- Button open internally
- Signal wire shorted to positive
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside P071C.
- 2Inspect electrical connectors, fuses, and harnesses connected to Transmission Mode Switch.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside P071C?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Transmission Mode Switch.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Transmission Mode Switch.
- 5Clear fault memory and run a verification cycle to confirm P071C does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $16 – $136 |
| Professional Repair (Parts + Labor) | $43 – $324 |
Frequently Asked Questions
Is it safe to keep operating with fault code P071C?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair P071C?
DIY replacement parts average $16–$136, while professional service averages $43–$324.
Will resetting P071C fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Transmission & Drivetrain)