P0705 Fault Code: Transmission Range Sensor A Circuit (PRNDL Input)
OBD-II P0705 (Transmission & Drivetrain): Transmission Range Sensor A Circuit (PRNDL Input).
OBD-II fault code P0705 indicates Transmission Range Sensor A Circuit (PRNDL Input). Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$486.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Moderate (Intermediate)
- System
- Transmission & Drivetrain
- Professional Repair
- $86 – $486
What This Fault Code Means
The transmission range sensor (selector or multifunction switch, PRNDL) reports the selected range; it may be a multi-contact switch with a bit pattern per position, an analog sensor with two opposing voltages adding up to 5 V, or a contactless PWM sensor. Its second channel has its own codes (P2801–P2805). P0705 is the circuit or pattern fault: the module receives a combination that matches no valid position. Ford flags an invalid pattern after 5 s (digital sensor) or 200 ms (4-bit sensor), checking continuously with the check engine light; Saab's 9-5 (9600) detects an impossible combination of its four contacts and goes into limp mode with the gearbox warning. The transmission no longer knows the range reliably – limp mode, start interlock or reversing light may be affected. Check the harness for shorts to ground before replacing the sensor.
Common Symptoms
- Check engine and/or transmission warning lamp
- Transmission limp mode, fixed gear, harsh shifts
- Starting problems in P/N or start interlock
- Wrong gear indication, reversing light not working
Most Likely Root Causes
- Range sensor worn, dirty or with oil or water ingress
- Sensor misadjusted or selector cable out of adjustment
- Harness or connector at the transmission damaged, short to ground
- Transmission or engine module input faulty
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside P0705.
- 2Inspect electrical connectors, fuses, and harnesses connected to Transmission Range Sensor.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside P0705?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Transmission Range Sensor.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Transmission Range Sensor.
- 5Clear fault memory and run a verification cycle to confirm P0705 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $30 – $204 |
| Professional Repair (Parts + Labor) | $86 – $486 |
Frequently Asked Questions
Is it safe to keep operating with fault code P0705?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair P0705?
DIY replacement parts average $30–$204, while professional service averages $86–$486.
Will resetting P0705 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Transmission & Drivetrain)