P042F Fault Code: EGR A Control Stuck Closed
OBD-II P042F (Catalytic & Exhaust Emissions): EGR A Control Stuck Closed.
OBD-II fault code P042F indicates EGR A Control Stuck Closed. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $162–$972.
- Safe to Operate?
- Yes (Short Term)
- DIY Difficulty
- Moderate (Intermediate)
- System
- Catalytic & Exhaust Emissions
- Professional Repair
- $162 – $972
What This Fault Code Means
Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. P042F means EGR valve A does not follow the opening command: its actual position stays more closed than commanded although the actuator works with high opening duty. GM's diesels of 2016/17 set it after about 1–8 s with MIL on the first trip; a GM bulletin covers it on the 2017 Cruze diesel. Ford petrol engines use position limits for 4 s; Ford diesels report both directions under P042E. With too little EGR, NOx rises, petrol engines may knock and P0401 can follow.
Common Symptoms
- Check engine light on (GM after one trip)
- Usually no driveability problems
- Possibly pinging (petrol) or higher NOx
Most Likely Root Causes
- Valve coked or seized in the closed position
- Actuator motor or gear weak or faulty
- Position sensor or connector gives a wrong value
- Icing in winter (temporary)
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside P042F.
- 2Inspect electrical connectors, fuses, and harnesses connected to Egr Valve.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside P042F?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Egr Valve.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Egr Valve.
- 5Clear fault memory and run a verification cycle to confirm P042F does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $57 – $408 |
| Professional Repair (Parts + Labor) | $162 – $972 |
Frequently Asked Questions
Is it safe to keep operating with fault code P042F?
Usually safe for short trips if no severe drivability or safety warnings are active.
How much does it cost to repair P042F?
DIY replacement parts average $57–$408, while professional service averages $162–$972.
Will resetting P042F fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Catalytic & Exhaust Emissions)