P042E Fault Code: EGR A Control Stuck Open
OBD-II P042E (Catalytic & Exhaust Emissions): EGR A Control Stuck Open.
OBD-II fault code P042E indicates EGR A Control Stuck Open. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $162–$972.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Moderate (Intermediate)
- System
- Catalytic & Exhaust Emissions
- Professional Repair
- $162 – $972
What This Fault Code Means
Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. P042E means the position-controlled EGR valve A is more open than commanded and cannot be closed. GM's diesels of 2016/17 set it when the valve stays too far open despite maximum closing duty (about 1–8 s); the 2018 tables check after switch-off whether it is below 5 % within 2 s – both with MIL on the first trip. Ford petrol engines compare the position with limits for 4 s, Ford diesels a deviation above 15 % for 25 s. Too much EGR causes rough idle, stalling and smoke; EGR control is switched off.
Common Symptoms
- Check engine light on (GM after one trip)
- Rough idle, stalling, starting problems
- Loss of power, possibly limp mode
- Diesel: smoke, higher soot load
Most Likely Root Causes
- Valve or disc coked, does not close
- Actuator motor, gear or return spring faulty
- Position sensor in the valve reads wrong
- Weak supply to the drive or connector fault
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside P042E.
- 2Inspect electrical connectors, fuses, and harnesses connected to Egr Valve.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside P042E?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Egr Valve.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Egr Valve.
- 5Clear fault memory and run a verification cycle to confirm P042E does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $57 – $408 |
| Professional Repair (Parts + Labor) | $162 – $972 |
Frequently Asked Questions
Is it safe to keep operating with fault code P042E?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair P042E?
DIY replacement parts average $57–$408, while professional service averages $162–$972.
Will resetting P042E fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Catalytic & Exhaust Emissions)