P042C Fault Code: Catalyst Temperature Sensor Circuit Low Bank 1 Sensor 2
OBD-II P042C (Catalytic & Exhaust Emissions): Catalyst Temperature Sensor Circuit Low Bank 1 Sensor 2.
OBD-II fault code P042C indicates Catalyst Temperature Sensor Circuit Low Bank 1 Sensor 2. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $65–$324.
- Safe to Operate?
- Yes (Short Term)
- DIY Difficulty
- Moderate (Intermediate)
- System
- Catalytic & Exhaust Emissions
- Professional Repair
- $65 – $324
What This Fault Code Means
Some engines – mainly diesels – measure the temperature at or in the catalyst with a thermistor in a voltage divider instead of only modelling it; most makers report exhaust temperature sensors under P0544 ff, P2031 ff or P2080 ff instead. Sensor 2 of bank 1 is a second, further downstream catalyst temperature sensor on the side with cylinder 1. P042C means the signal voltage is below its lower limit – typically the signal wire is shorted to ground or the sensor is shorted internally. No manufacturer document available to us uses this code; the description follows CARB, which requires input circuits to be checked for circuit faults and plausibility, and the comparable exhaust temperature sensors.
Common Symptoms
- Check engine light on
- Usually no noticeable change (substitute value from the model)
- Diesel: filter regeneration distorted or blocked, possibly further codes such as P2459 or P0420
Most Likely Root Causes
- Signal wire shorted to ground (chafed)
- Sensor shorted internally
- Water or corrosion in the connector
- Engine module
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside P042C.
- 2Inspect electrical connectors, fuses, and harnesses connected to Catalyst Temperature Sensor B1S2.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside P042C?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Catalyst Temperature Sensor B1S2.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Catalyst Temperature Sensor B1S2.
- 5Clear fault memory and run a verification cycle to confirm P042C does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $23 – $136 |
| Professional Repair (Parts + Labor) | $65 – $324 |
Frequently Asked Questions
Is it safe to keep operating with fault code P042C?
Usually safe for short trips if no severe drivability or safety warnings are active.
How much does it cost to repair P042C?
DIY replacement parts average $23–$136, while professional service averages $65–$324.
Will resetting P042C fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Catalytic & Exhaust Emissions)