FaultCodes.org
P0429OBD-IICatalytic & Exhaust EmissionsTechnical Reference· Updated: Nov 22, 2026

P0429 Fault Code: Catalyst Heater Control Circuit/Open Bank 1

OBD-II P0429 (Catalytic & Exhaust Emissions): Catalyst Heater Control Circuit/Open Bank 1.

Quick AnswerModerate — Plan Repair

OBD-II fault code P0429 indicates Catalyst Heater Control Circuit/Open Bank 1. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$2700.

Safe to Operate?
Yes (Short Term)
DIY Difficulty
Moderate (Intermediate)
System
Catalytic & Exhaust Emissions
Professional Repair
$54 – $2,700

What This Fault Code Means

An electrically heated catalyst has a heating disc ahead of a support catalyst so that it works soon after a cold start (Emitec EMICAT, 12–48 V); it was tried on Californian petrol cars in the 1990s and is used today mainly on diesels, for example Audi's 3.0 TDI from 2014 and 48-volt diesel vans. P0429 is the electrical check of the catalyst heater of bank 1 (the side with cylinder 1): the module drives it via a relay or power stage and detects an open control circuit or heating element from the driver feedback, as CARB requires for output circuits. The heater then fails, the catalyst lights off later and P0424/P0434 may follow; the engine itself runs normally. No manufacturer document available to us uses this code.

Common Symptoms

  • Check engine light on
  • Higher emissions after a cold start
  • Otherwise usually unremarkable

Most Likely Root Causes

  • Wire or connector to the heating element open (heat, corrosion)
  • Heating element burnt out
  • Relay, fuse or power stage faulty
  • Engine module

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside P0429.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Catalyst Heater.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside P0429?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Catalyst Heater.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Catalyst Heater.
  5. 5Clear fault memory and run a verification cycle to confirm P0429 does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$19 – $1,134
Professional Repair (Parts + Labor)$54 – $2,700

Frequently Asked Questions

Is it safe to keep operating with fault code P0429?

Usually safe for short trips if no severe drivability or safety warnings are active.

How much does it cost to repair P0429?

DIY replacement parts average $19–$1134, while professional service averages $54–$2700.

Will resetting P0429 fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

P0429 fault code meaningP0429 repair costhow to fix P0429

Manufacturer & Technical Reference

OBD-II Technical Reference (Catalytic & Exhaust Emissions)

Related Fault Codes

Auto & OBD-II →
P0429 Fault Code: Catalyst Heater Control Circuit/Open Bank 1 | FaultCodes.org