P0428 Fault Code: Catalyst Temperature Sensor Circuit High Bank 1 Sensor 1
OBD-II P0428 (Catalytic & Exhaust Emissions): Catalyst Temperature Sensor Circuit High Bank 1 Sensor 1.
OBD-II fault code P0428 indicates Catalyst Temperature Sensor Circuit High Bank 1 Sensor 1. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $65–$324.
- Safe to Operate?
- Yes (Short Term)
- DIY Difficulty
- Moderate (Intermediate)
- System
- Catalytic & Exhaust Emissions
- Professional Repair
- $65 – $324
What This Fault Code Means
Some engines – mainly diesels – measure the temperature at or in the catalyst with a thermistor in a voltage divider instead of only modelling it; most makers report exhaust temperature sensors under P0544 ff, P2031 ff or P2080 ff instead. Sensor 1 of bank 1 is the first catalyst temperature sensor on the side with cylinder 1. P0428 means the signal voltage is above its upper limit – typically the sensor or its wiring is open, or the signal is shorted to positive. FCA's 3.0-litre EcoDiesel uses this sensor (middle of the oxidation catalyst and particulate filter unit), but no document available to us names this particular code.
Common Symptoms
- Check engine light on
- Usually no noticeable change (substitute value from the model)
- Diesel: filter regeneration distorted or blocked, possibly further codes such as P2459 or P0420
Most Likely Root Causes
- Sensor or wire open (broken by vibration or heat)
- Connector off or loose, ground wire open
- Signal wire shorted to positive
- Engine module
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside P0428.
- 2Inspect electrical connectors, fuses, and harnesses connected to Catalyst Temperature Sensor B1S1.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside P0428?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Catalyst Temperature Sensor B1S1.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Catalyst Temperature Sensor B1S1.
- 5Clear fault memory and run a verification cycle to confirm P0428 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $23 – $136 |
| Professional Repair (Parts + Labor) | $65 – $324 |
Frequently Asked Questions
Is it safe to keep operating with fault code P0428?
Usually safe for short trips if no severe drivability or safety warnings are active.
How much does it cost to repair P0428?
DIY replacement parts average $23–$136, while professional service averages $65–$324.
Will resetting P0428 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Catalytic & Exhaust Emissions)