P0425 Fault Code: Catalyst Temperature Sensor Circuit Bank 1 Sensor 1
OBD-II P0425 (Catalytic & Exhaust Emissions): Catalyst Temperature Sensor Circuit Bank 1 Sensor 1.
OBD-II fault code P0425 indicates Catalyst Temperature Sensor Circuit Bank 1 Sensor 1. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $65–$324.
- Safe to Operate?
- Yes (Short Term)
- DIY Difficulty
- Moderate (Intermediate)
- System
- Catalytic & Exhaust Emissions
- Professional Repair
- $65 – $324
What This Fault Code Means
Some engines – mainly diesels – measure the temperature at or in the catalyst with a thermistor in a voltage divider instead of only modelling it; most makers report exhaust temperature sensors under P0544 ff, P2031 ff or P2080 ff instead. Sensor 1 of bank 1 is the first catalyst temperature sensor on the side with cylinder 1. P0425 is the general circuit fault, used where the module does not separate low and high. FCA's 3.0-litre EcoDiesel uses this sensor (middle of the oxidation catalyst and particulate filter unit), but no document available to us names this particular code.
Common Symptoms
- Check engine light on
- Usually no noticeable change (substitute value from the model)
- Diesel: filter regeneration distorted or blocked, possibly further codes such as P2459 or P0420
Most Likely Root Causes
- Sensor faulty (element or lead broken by heat or vibration)
- Harness chafed or scorched at the exhaust, connector corroded
- Connector loose or pins pushed back
- Engine module input
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside P0425.
- 2Inspect electrical connectors, fuses, and harnesses connected to Catalyst Temperature Sensor B1S1.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside P0425?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Catalyst Temperature Sensor B1S1.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Catalyst Temperature Sensor B1S1.
- 5Clear fault memory and run a verification cycle to confirm P0425 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $23 – $136 |
| Professional Repair (Parts + Labor) | $65 – $324 |
Frequently Asked Questions
Is it safe to keep operating with fault code P0425?
Usually safe for short trips if no severe drivability or safety warnings are active.
How much does it cost to repair P0425?
DIY replacement parts average $23–$136, while professional service averages $65–$324.
Will resetting P0425 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Catalytic & Exhaust Emissions)