P0423 Fault Code: Heated Catalyst Efficiency Below Threshold Bank 1
OBD-II P0423 (Catalytic & Exhaust Emissions): Heated Catalyst Efficiency Below Threshold Bank 1.
OBD-II fault code P0423 indicates Heated Catalyst Efficiency Below Threshold Bank 1. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $162–$3240.
- Safe to Operate?
- Yes (Short Term)
- DIY Difficulty
- Professional Recommended
- System
- Catalytic & Exhaust Emissions
- Professional Repair
- $162 – $3,240
What This Fault Code Means
An electrically heated catalyst has a heating disc ahead of a support catalyst so that it works soon after a cold start (Emitec EMICAT, 12–48 V); it was tried on Californian petrol cars in the 1990s and is used today mainly on diesels, for example Audi's 3.0 TDI from 2014 and 48-volt diesel vans. P0423 means the heated catalyst of bank 1 (the side with cylinder 1) no longer converts enough; CARB requires it to be assessed like any other catalyst. The only manufacturer reference is two Ram software bulletins for the 6.7-litre Cummins HO (model years 2025/26), which list P0423 without saying which part is meant.
Common Symptoms
- Check engine light on
- Higher emissions after a cold start
- Otherwise usually unremarkable
Most Likely Root Causes
- Heated catalyst aged or poisoned
- Heater not working, catalyst active too late
- Sensor used for the assessment faulty
- Calibration (Ram: software update per bulletin)
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside P0423.
- 2Inspect electrical connectors, fuses, and harnesses connected to Electrically Heated Catalyst.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside P0423?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Electrically Heated Catalyst.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Electrically Heated Catalyst.
- 5Clear fault memory and run a verification cycle to confirm P0423 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $57 – $1,361 |
| Professional Repair (Parts + Labor) | $162 – $3,240 |
Certified Technician Service Checklist
This fault involves sealed safety, gas, or high-voltage systems. Share these details when requesting a repair quote.
- Share exact brand & fault code: P0423 (Catalytic & Exhaust Emissions)
- Record appliance/boiler serial, model plate, or pressure reading before calling
- Typical certified technician range: $162 – $3,240
Frequently Asked Questions
Is it safe to keep operating with fault code P0423?
Usually safe for short trips if no severe drivability or safety warnings are active.
How much does it cost to repair P0423?
DIY replacement parts average $57–$1361, while professional service averages $162–$3240.
Will resetting P0423 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Catalytic & Exhaust Emissions)