P0315 Fault Code: Crankshaft Position System Variation Not Learned
OBD-II P0315 (Ignition & Misfire System): Crankshaft Position System Variation Not Learned.
OBD-II fault code P0315 indicates Crankshaft Position System Variation Not Learned. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $54–$216.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Moderate (Intermediate)
- System
- Ignition & Misfire System
- Professional Repair
- $54 – $216
What This Fault Code Means
Manufacturing tolerances of the crankshaft tone wheel distort the speed fluctuations misfire detection relies on, so the engine module learns a correction for each tooth or segment. P0315 means these values have not been learned or are invalid. GM checks that the learned tooth angles add up to 360° (deviation above 0.001° sets the code in the first trip) and learns them with a scan tool: brakes held, full throttle in park until fuel cut-off. Ford learns the profile during up to three overrun phases from 60 to 40 mph and sets P0315 when that fails. Until relearned, misfire detection is suspended – at GM above 1,000 rpm – and misfire readiness stays incomplete. The relearn is needed after replacing the engine, engine module, crankshaft, damper or crankshaft sensor.
Common Symptoms
- Check engine light on (GM; Ford depending on application)
- Driving usually unaffected
- Misfire readiness not set – emissions test fails
Most Likely Root Causes
- Relearn not performed after replacing sensor, crankshaft, damper, engine or engine module
- Learned values lost through voltage loss (battery disconnected)
- Tone wheel damaged or shifted, crankshaft runout, dirt on the sensor
- Interference in the crankshaft sensor circuit
- Engine module memory faulty
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside P0315.
- 2Inspect electrical connectors, fuses, and harnesses connected to Crankshaft Position Sensor.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside P0315?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Crankshaft Position Sensor.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Crankshaft Position Sensor.
- 5Clear fault memory and run a verification cycle to confirm P0315 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $19 – $91 |
| Professional Repair (Parts + Labor) | $54 – $216 |
Frequently Asked Questions
Is it safe to keep operating with fault code P0315?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair P0315?
DIY replacement parts average $19–$91, while professional service averages $54–$216.
Will resetting P0315 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Ignition & Misfire System)