P0299 Fault Code: Turbocharger / Supercharger "A" Underboost Condition
Actual boost pressure lagged significantly behind target boost—such as >4 psi (28 kPa) for 5 seconds on Ford EcoBoost or 30–55 kPa below target on GM petrol engines—most commonly caused by boost hose leaks, worn wastegate rods, diverter diaphragms, or winter intercooler icing.
Code P0299 sets when measured turbocharger boost trails ECM demand past OEM underboost thresholds: Ford EcoBoost monitors trip when boost stays > 4 psi (~28 kPa) below target for 5 seconds with the wastegate commanded shut, while GM gasoline thresholds sit at 30–55 kPa below target on the first trip (diesels 10–50 kPa across two trips). Gentle low-load driving to a repair shop is generally safe if there is no metal grinding or heavy oil smoke, though the engine often enters limp mode. Always boost-leak test intercooler pipes, diverter diaphragms, wastegate actuator preload/rods, and winter intercooler ice before ever replacing a turbocharger ($25–$260 DIY hoses/valves; $220–$2,400 shop/turbo).
- Safe to Operate?
- Yes (Short Term)
- DIY Difficulty
- Moderate (Intermediate)
- System
- Powertrain & Engine Management
- Professional Repair
- $220 – $2,400
What This Fault Code Means
During throttle acceleration, the ECM targets calculated boost on the MAP/Boost sensor by holding the wastegate or VGT vanes closed. Manufacturer service bulletins attribute most P0299 underboost events to pressurized charge-air hose leaks, a wastegate rod losing preload or detaching, torn bypass/diverter valve diaphragms, sticking diesel VGT vanes, winter ice plugging the bottom of the intercooler, or a skewed boost pressure sensor faking low psi.
Common Symptoms
- Sudden lack of acceleration power on highway merges or uphill climbs ('turbo limp mode')
- Whooshing, whistling, or escaping-air noise from under the hood while building boost
- Check Engine Light activating under load—sometimes paired with diesel underboost code
P2263or winter hesitation
Most Likely Root Causes
- Split, popped-off, or oil-softened intercooler/charge hose, loose clamps, or winter condensation freezing inside the charge air cooler
- Wastegate actuator losing preload, detached linkage clip/rod, worn bushing, or cracked vacuum/control diaphragm
- Torn rubber diaphragm inside the turbo bypass/diverter valve or faulty boost control solenoid (
N75) - Sticking VGT turbo vanes on diesel engines, clogged DPF/catalyst backpressure, skewed MAP/Boost sensor, or worn turbo bearings
Technical Thresholds & Specifications
| Parameter / Condition | Factory Spec / Threshold |
|---|---|
| Ford EcoBoost Petrol Threshold Triggered when wastegate is already commanded 100% closed (Motorcraft OBD Summary) | > 4 psi (~28 kPa) deficit for 5 s |
| GM Gasoline Underboost Threshold Immediate single-trip warning light when boost demand fails | 30–55 kPa below target (1st trip MIL) |
| GM Diesel Underboost Threshold Often associated with sticking VGT turbo vanes or charge pipe leaks | 10–50 kPa deficit (2 trips) |
| Ford Diesel Underboost Threshold Frequently paired with companion diesel turbo boost code P2263 | 30–40 kPa deficit for 10–15 s |
Commonly Affected Models & Service Bulletins
- Ford EcoBoost 1.5L / 2.0L / 3.5L & Ford Power Stroke Diesel (Motorcraft Gasoline & Diesel OBD Summaries)
- GM Turbocharged Gasoline & Diesel Engines (GM Mode 6 18OBDG03A / 18OBDG04; NHTSA TSBs MC-10126208 & MC-10175745)
- VW / Audi 2.0 TSI & TDI Engines (torn diverter valve diaphragms, worn wastegate linkage, winter intercooler icing)
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Inspect all turbo-to-intercooler and intercooler-to-throttle charge pipes and couplers for oil mist buildup (oil mist sprays outward around torn seams under boost).
- 2Monitor live OBD-II
Commanded Boost / MAPvsActual Boostunder moderate load, plus verify Key-On Engine-Off boost pressure matches ambient barometric air pressure (~14.5–14.7 psi / ~100 kPa at sea level). - 3Perform a 10–15 psi smoke / pressure boost-leak test from the turbo inlet to the throttle body, and hand-vacuum/pressure test the wastegate actuator rod for detached clips or binding.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Does a 10–15 psi smoke/pressure test leak air around intercooler hoses, couplers, or plastic charge pipes?
Step-by-Step Troubleshooting & Fix
Tools & Parts Reference
- 1Tighten loose T-bolt/worm clamps and replace split rubber intercooler hoses, worn O-ring couplers, or cracked plastic charge pipes.
- 2Remove and inspect the diverter/bypass valve diaphragm and wastegate rod/linkage—replace torn valves or loose retaining clips and verify proper wastegate preload.
- 3Inspect thin vacuum control lines (for cracks or rodent bites) and test/replace a sticking boost control solenoid (
N75). - 4If charge pipes hold pressure tightly yet boost still trails target, inspect diesel VGT vane movement, exhaust DPF/cat restriction, or turbocharger axial/radial shaft play.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $25 – $260 |
| Professional Repair (Parts + Labor) | $220 – $2,400 |
Recommended Diagnostic Tools & Replacement Parts
Check OEM specifications and compatible tools for this repair.
Frequently Asked Questions
Does P0299 mean my turbocharger is definitely ruined?
No—manufacturer service bulletins overwhelmingly trace P0299 to torn charge hoses, popped clamps, torn bypass/diverter valve diaphragms, loose wastegate rods, or clogged boost solenoids rather than a dead turbo core.
Can freezing winter weather cause P0299?
Yes! Manufacturer OBD bulletins specifically document moisture condensation pooling and freezing inside the bottom of intercoolers during cold snaps, choking airflow and triggering temporary P0299 underboost.