FaultCodes.org
P013EOBD-IIFuel Trim & Air/O2 MeteringTechnical Reference· Updated: Nov 22, 2026

P013E Fault Code: O2 Sensor Delayed Response - Rich to Lean Bank 1 Sensor 2

OBD-II P013E (Fuel Trim & Air/O2 Metering): O2 Sensor Delayed Response - Rich to Lean Bank 1 Sensor 2.

Quick AnswerModerate — Plan Repair

OBD-II fault code P013E indicates O2 Sensor Delayed Response - Rich to Lean Bank 1 Sensor 2. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $65–$270.

Safe to Operate?
Yes (Short Term)
DIY Difficulty
Easy (Basic Tools)
System
Fuel Trim & Air/O2 Metering
Professional Repair
$65 – $270

What This Fault Code Means

The downstream oxygen sensor (sensor 2, after the catalytic converter) is used for fine mixture trim and to monitor the converter. 'Delayed response' means the sensor starts reacting too late, or does not reach the target level at all, after the mixture has changed. This code covers the rich-to-lean direction, usually tested during deceleration fuel cut-off. GM checks whether the signal falls below 450 mV before about 45 g of air have passed after the forced change; failing needs two trips. Ford counts it as stuck in range if the sensor does not drop below 0.1 V within 5–10 s of fuel cut-off. Bulletins often point elsewhere: Audi fixed P013E with software and said not to replace the sensor, VW names exhaust leaks or the converter. CARB requires separate detection of slow and delayed faults in each direction (phased in from 2009 for downstream and 2011 for upstream sensors).

Common Symptoms

  • Check engine light on
  • Usually no noticeable change in driving
  • Catalyst monitor may stay incomplete (inspection readiness missing)
  • With a converter cause, P0420/P0430 may follow

Most Likely Root Causes

  • Downstream oxygen sensor aged or contaminated (soot, oil, silicone, coolant)
  • Exhaust leak between manifold/turbo and the sensor
  • Converter faulty or non-original with different oxygen storage
  • Control module software too sensitive (update available)
  • Sensor connector or wiring with contact resistance

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside P013E.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Oxygen Sensor Bank1 Sensor2.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside P013E?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Oxygen Sensor Bank1 Sensor2.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Oxygen Sensor Bank1 Sensor2.
  5. 5Clear fault memory and run a verification cycle to confirm P013E does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$23 – $113
Professional Repair (Parts + Labor)$65 – $270

Frequently Asked Questions

Is it safe to keep operating with fault code P013E?

Usually safe for short trips if no severe drivability or safety warnings are active.

How much does it cost to repair P013E?

DIY replacement parts average $23–$113, while professional service averages $65–$270.

Will resetting P013E fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

P013E fault code meaningP013E repair costhow to fix P013E

Manufacturer & Technical Reference

OBD-II Technical Reference (Fuel Trim & Air/O2 Metering)

Related Fault Codes

Auto & OBD-II →
P013E Fault Code: O2 Sensor Delayed Response - Rich… — Fixes & Cost | FaultCodes.org