FaultCodes.org
P0129OBD-IIEngine Cooling & ThermostatTechnical Reference· Updated: Nov 22, 2026

P0129 Fault Code: Barometric Pressure Too Low

OBD-II P0129 (Engine Cooling & Thermostat): Barometric Pressure Too Low.

Quick AnswerHigh — Service Soon

OBD-II fault code P0129 indicates Barometric Pressure Too Low. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$270.

Safe to Operate?
No — Risk of Damage
DIY Difficulty
Easy (Basic Tools)
System
Engine Cooling & Thermostat
Professional Repair
$43 – $270

What This Fault Code Means

The engine control module needs the ambient air pressure for mixture, altitude correction and boost limits. It comes either from a dedicated barometric sensor or from the MAP sensor, read at key-on with the engine stopped and updated at wide-open throttle. P0129 means this value is lower than physically possible – even on the highest drivable passes air pressure stays around 50 kPa, and GM and Ford use 50 kPa as their lower plausibility limit. Usual causes are a MAP or baro sensor reading too low, a blocked sensor port or high resistance in the wiring. No manufacturer document naming exactly this code was found: GM and Ford file the same finding under P2227.

Common Symptoms

  • Check engine light on
  • Rich mixture, higher consumption, rough idle
  • Loss of power (altitude-corrected boost limits)

Most Likely Root Causes

  • MAP or baro sensor reading too low (dirty, oiled, drifted)
  • High resistance or corrosion in signal wire or connector
  • Sensor port or hose blocked
  • Control module (baro sensor often built in) or software

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside P0129.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Barometric Pressure Sensor.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside P0129?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Barometric Pressure Sensor.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Barometric Pressure Sensor.
  5. 5Clear fault memory and run a verification cycle to confirm P0129 does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$16 – $113
Professional Repair (Parts + Labor)$43 – $270

Frequently Asked Questions

Is it safe to keep operating with fault code P0129?

Avoid prolonged operation until inspected to prevent secondary component damage.

How much does it cost to repair P0129?

DIY replacement parts average $16–$113, while professional service averages $43–$270.

Will resetting P0129 fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

P0129 fault code meaningP0129 repair costhow to fix P0129

Manufacturer & Technical Reference

OBD-II Technical Reference (Engine Cooling & Thermostat)

Related Fault Codes

Auto & OBD-II →
P0129 Fault Code: Barometric Pressure Too Low — Causes, Fixes & Cost | FaultCodes.org