P010B Fault Code: Mass or Volume Air Flow Sensor B Circuit Range/Performance
OBD-II P010B (Fuel Trim & Air/O2 Metering): Mass or Volume Air Flow Sensor B Circuit Range/Performance.
OBD-II fault code P010B indicates Mass or Volume Air Flow Sensor B Circuit Range/Performance. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$432.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Easy (Basic Tools)
- System
- Fuel Trim & Air/O2 Metering
- Professional Repair
- $43 – $432
What This Fault Code Means
Sensor B is a second mass air flow sensor in a second intake path, found on engines with two air filter boxes – for example the Nissan VR30DDTT twin-turbo V6 (where sensor B belongs to bank 2) or GM's 3.0 litre twin-turbo V6. P010B is the plausibility fault of sensor B: the signal is electrically valid but does not fit. GM checks it like sensor A against a model built from the other sensors (manifold pressure, boost, throttle, sensor A) and fails it above 20 g/s deviation, with two trips. For the VR30DDTT Nissan names a loose or leaking left-hand intake pipe as the main cause and warns against touching or dismantling the sensor. Other causes match P0101: a soiled element, a clogged filter on that side or a boost leak.
Common Symptoms
- Check engine light on
- Lack of power, hesitation
- Rough idle
- Bank 2 mixture codes (P0174) possible
Most Likely Root Causes
- Intake pipe on the sensor B side leaking or not seated
- Sensor B element contaminated (oil, dust)
- Air filter on that side clogged or wrongly fitted
- Boost leak on that bank, or sensor/connector problem
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside P010B.
- 2Inspect electrical connectors, fuses, and harnesses connected to Mass Air Flow Sensor B.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside P010B?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Mass Air Flow Sensor B.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Mass Air Flow Sensor B.
- 5Clear fault memory and run a verification cycle to confirm P010B does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $16 – $181 |
| Professional Repair (Parts + Labor) | $43 – $432 |
Frequently Asked Questions
Is it safe to keep operating with fault code P010B?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair P010B?
DIY replacement parts average $16–$181, while professional service averages $43–$432.
Will resetting P010B fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Fuel Trim & Air/O2 Metering)