C0049 Fault Code: Brake Fluid Level
OBD-II C0049 (Chassis, ABS & Stability Control): Brake Fluid Level.
OBD-II fault code C0049 indicates Brake Fluid Level. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$432.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Easy (Basic Tools)
- System
- Chassis, ABS & Stability Control
- Professional Repair
- $43 – $432
What This Fault Code Means
Covers the brake fluid level input to the brake or stability module, used to warn the driver and to disable functions that must not run with low fluid. A float switch or sensor in the master-cylinder reservoir signals when fluid drops below a safe level; the module sets this code and lights the red brake warning indicator. A genuine low level usually means worn brake pads that have drawn fluid into the calipers or a leak in the hydraulic system, but Ford documents cases on 2021-2025 Bronco and 2024 Mustang where a false low-level message with C0049 (sub-types :01, :0A) was caused by the reservoir or its sensor and resolved by replacing the reservoir. Low fluid can disable ABS and stability control; the condition should always be inspected because it can indicate a leak.
Common Symptoms
- Red brake warning indicator on
- Low brake fluid message
- ABS and stability control may be disabled
Most Likely Root Causes
- Low fluid from worn pads or a leak
- Faulty reservoir level sensor or float
- Reservoir fault causing false reading
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside C0049.
- 2Inspect electrical connectors, fuses, and harnesses connected to Brake Fluid Reservoir.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside C0049?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Brake Fluid Reservoir.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Brake Fluid Reservoir.
- 5Clear fault memory and run a verification cycle to confirm C0049 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $16 – $181 |
| Professional Repair (Parts + Labor) | $43 – $432 |
Frequently Asked Questions
Is it safe to keep operating with fault code C0049?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair C0049?
DIY replacement parts average $16–$181, while professional service averages $43–$432.
Will resetting C0049 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Chassis, ABS & Stability Control)