C003B Fault Code: Right Rear Wheel Speed Sensor Supply
OBD-II C003B (Chassis, ABS & Stability Control): Right Rear Wheel Speed Sensor Supply.
OBD-II fault code C003B indicates Right Rear Wheel Speed Sensor Supply. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $65–$486.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Moderate (Intermediate)
- System
- Chassis, ABS & Stability Control
- Professional Repair
- $65 – $486
What This Fault Code Means
Covers the supply circuit that powers the right rear active wheel speed sensor, completing the supply set with C0032 and C0038. Active sensors need a regulated voltage from the ABS/ESC module; this code is set when that supply is open, shorted to ground or to another voltage, or outside the regulated range so the sensor cannot produce a valid signal. It is distinct from the sensor-signal code C003A in that the fault is on the feed rather than in the sensor element. A fault disables ABS, traction and stability control for that corner and lights the ABS warning lamp while base braking remains. No manufacturer documents this code publicly; NHTSA lists C003B as right rear supply in the J2012 table of its EPS safety report.
Common Symptoms
- ABS warning lamp on
- ABS and stability control disabled
- No wheel speed signal from this corner
Most Likely Root Causes
- Open or shorted sensor supply wire
- Corroded connector on the supply side
- Module sensor supply output fault
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside C003B.
- 2Inspect electrical connectors, fuses, and harnesses connected to Rr Wss.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside C003B?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Rr Wss.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Rr Wss.
- 5Clear fault memory and run a verification cycle to confirm C003B does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $23 – $204 |
| Professional Repair (Parts + Labor) | $65 – $486 |
Frequently Asked Questions
Is it safe to keep operating with fault code C003B?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair C003B?
DIY replacement parts average $23–$204, while professional service averages $65–$486.
Will resetting C003B fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Chassis, ABS & Stability Control)