Chevy P1163 Fault Code: HO2S Bank 2 Sensor 3 Lean System Or Low Voltage
Chevy P1163 (Powertrain & Engine Management): HO2S Bank 2 Sensor 3 Lean System Or Low Voltage.
Chevy fault code P1163 indicates HO2S Bank 2 Sensor 3 Lean System Or Low Voltage. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $130–$594.
- Safe to Operate?
- Yes (Short Term)
- DIY Difficulty
- Moderate (Intermediate)
- System
- Powertrain & Engine Management
- Professional Repair
- $130 – $594
What This Fault Code Means
Manufacturer-specific Chevy diagnostic trouble code P1163: HO2S Bank 2 Sensor 3 Lean System Or Low Voltage.
Common Symptoms
- Warning indicator or active diagnostic code P1163
- Irregular behavior in Powertrain & Engine Management
Most Likely Root Causes
- Faulty sensor or actuator in Powertrain & Engine Management
- Damaged, corroded, or loose wiring harness connector
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside P1163.
- 2Inspect electrical connectors, fuses, and harnesses connected to Powertrain & Engine Management.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside P1163?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Powertrain & Engine Management.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Powertrain & Engine Management.
- 5Clear fault memory and run a verification cycle to confirm P1163 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $45 – $249 |
| Professional Repair (Parts + Labor) | $130 – $594 |
Frequently Asked Questions
Is it safe to keep operating with fault code P1163?
Usually safe for short trips if no severe drivability or safety warnings are active.
How much does it cost to repair P1163?
DIY replacement parts average $45–$249, while professional service averages $130–$594.
Will resetting P1163 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
Chevy Technical Reference (Powertrain & Engine Management)
Related Fault Codes
Auto & OBD-II →OBD-II P0401: Exhaust Gas Recirculation (EGR) Flow Insufficient Detected
SAE J2012 emissions code set when EGR valve commands fail to produce expected **DPFE pressure, MAP/MAF change, or EGR temperature rise**—often caused by **carbon-clogged intake ports or failing DPFE sensors** rather than the valve itself.
OBD-II P0507: Idle Air Control (IAC) System RPM Higher Than Expected
OBD-II P0011: "A" Camshaft Position Timing Over-Advanced (Bank 1)
OBD-II P0411: Secondary Air Injection (SAIR) System Incorrect Flow Detected
OBD-II P2096: Post Catalyst Fuel Trim System Too Lean (Bank 1)