# OBD-II U0042: Vehicle Communication Bus B (-) Open

> **Quick Answer:** OBD-II fault code U0042 indicates Vehicle Communication Bus B (-) Open. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $65–$756.

- **URL:** https://faultcodes.org/automotive/obd2-u0042
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0042 points to an interrupted (-) wire on Vehicle Communication Bus B; on a CAN-type bus that is CAN-Low. The network then splits along the break, and on a standard high-speed CAN neither side's transceiver can tell what happened, since NXP states that line interruptions escape even transceiver diagnosis. Detection rests on time-outs for messages from nodes on the far side. On a fault-tolerant low-speed CAN, the TJA1055 data sheet from NXP treats a CAN-Low interruption as a failure that frames in progress survive. A resistance check across the two bus wires at a central connector helps: with both terminations reachable it reads about 60 ohms, a break in one wire leaves only the near terminator at about 120 ohms. No manufacturer documents U0042 publicly; start with connectors that were opened recently.

## Common Symptoms
- Modules beyond the break no longer respond
- Lost-communication codes stored alongside

## Most Likely Root Causes
- (-) wire of Bus B broken in the harness
- Corroded or pushed-back terminal in a connector
- Connector not reconnected after a repair

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Bus B Wiring.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Bus B Wiring.
5. Clear fault memory and run a verification cycle to confirm U0042 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$318 | $65–$756 |
| GBP | £18–£250 | £52–£602 |
| CAD | CA$30–CA$426 | CA$87–CA$1015 |
| EUR | €21–€294 | €60–€700 |
| CHF | CHF 24–CHF 338 | CHF 79–CHF 924 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0042?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair U0042?
DIY replacement parts average $23–$318, while professional service averages $65–$756.

### Will resetting U0042 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

