# OBD-II U0041: Vehicle Communication Bus B (+) High

> **Quick Answer:** OBD-II fault code U0041 indicates Vehicle Communication Bus B (+) High. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $65–$756.

- **URL:** https://faultcodes.org/automotive/obd2-u0041
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0041 means the (+) wire of Vehicle Communication Bus B sits at too high a voltage, typically because it touches a battery or 5 V supply. For a high-speed-type CAN this is CAN-High, and NXP classes a short of CAN-High to battery or to VCC as a hidden failure: frames keep flowing, so only a transceiver with bus diagnosis, such as the TJA1043, reports it. On a fault-tolerant low-speed CAN NXP's TJA1055 reacts in two steps after time-outs and finally switches off its CANH driver, running on CAN-Low alone. Either way the vehicle often behaves normally, and the code may sit in memory long before anything fails. No manufacturer documents U0041 publicly. A reading near supply voltage on CAN-High against ground confirms it; check for chafing against feed wires and moisture in connectors.

## Common Symptoms
- Often no noticeable symptom, code found during a scan
- Sporadic warnings from one module

## Most Likely Root Causes
- (+) wire chafed against a battery or 5 V feed
- Moisture in a connector bridging the (+) wire to a supply pin
- Faulty transceiver driving the (+) line high

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Bus B Wiring.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Bus B Wiring.
5. Clear fault memory and run a verification cycle to confirm U0041 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$318 | $65–$756 |
| GBP | £18–£250 | £52–£602 |
| CAD | CA$30–CA$426 | CA$87–CA$1015 |
| EUR | €21–€294 | €60–€700 |
| CHF | CHF 24–CHF 338 | CHF 79–CHF 924 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0041?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair U0041?
DIY replacement parts average $23–$318, while professional service averages $65–$756.

### Will resetting U0041 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

