# OBD-II U0040: Vehicle Communication Bus B (+) Low

> **Quick Answer:** OBD-II fault code U0040 indicates Vehicle Communication Bus B (+) Low. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $65–$864.

- **URL:** https://faultcodes.org/automotive/obd2-u0040
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0040 indicates the (+) line of Vehicle Communication Bus B pulled down to ground potential. On a high-speed-type CAN that is CAN-High, and onsemi's bench tests list it among the shorts that stop all transmission: each failed start of frame raises the transmit error counter by eight, the controller turns error passive after a handful of attempts and goes bus-off once the count passes 255. Meanwhile the CANH driver runs into its current limit. The same short is one of the failures that NXP's fault-tolerant TJA1055 rides out without corrupting frames. So the effect ranges from a completely silent Bus B to a degraded but working one, depending on the bus type. No manufacturer documents U0040 publicly. Measure CAN-High against ground with the battery off; chafed insulation is the usual culprit.

## Common Symptoms
- All functions on Bus B fail at once (high-speed type)
- Many lost-communication codes in modules on other networks
- Fallback modes or warning lamps depending on the modules involved

## Most Likely Root Causes
- (+) wire chafed through against body ground
- Harness crushed by a seat rail, bracket or panel
- Transceiver of one module pulling the (+) line to ground

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Bus B Wiring.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Bus B Wiring.
5. Clear fault memory and run a verification cycle to confirm U0040 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$363 | $65–$864 |
| GBP | £18–£286 | £52–£688 |
| CAD | CA$30–CA$487 | CA$87–CA$1160 |
| EUR | €21–€336 | €60–€800 |
| CHF | CHF 24–CHF 386 | CHF 79–CHF 1056 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0040?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair U0040?
DIY replacement parts average $23–$363, while professional service averages $65–$864.

### Will resetting U0040 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

