# OBD-II U0031: Vehicle Communication Bus A (+) Low

> **Quick Answer:** OBD-II fault code U0031 indicates Vehicle Communication Bus A (+) Low. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $65–$864.

- **URL:** https://faultcodes.org/automotive/obd2-u0031
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0031 indicates a ground short on the (+) conductor of Vehicle Communication Bus A. Where Bus A is a high-speed-style two-wire CAN, such as the sensor/hybrid CAN Audi assigns to this slot in its 48 V mild hybrids, the (+) wire is CAN-High, which has to rise by about a volt to form a dominant bit. Grounded, it cannot: onsemi's measurements list CAN-High to ground among the shorts under which transmission becomes impossible, so the controllers keep retrying in vain. Every node on Bus A then falls silent together, and modules on other networks record lost-communication codes for them. No manufacturer documents U0031 publicly. With the battery disconnected, a few ohms or less between CAN-High and ground locate the short; chafed harness sections are the usual cause.

## Common Symptoms
- All functions served by Bus A fail at once
- Many lost-communication codes in other modules
- Warning lamps or fallback modes depending on the modules involved

## Most Likely Root Causes
- (+) wire chafed through against body ground
- Harness trapped under a panel or bracket
- Transceiver of one module shorting the (+) line internally

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Bus A Wiring.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Bus A Wiring.
5. Clear fault memory and run a verification cycle to confirm U0031 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$363 | $65–$864 |
| GBP | £18–£286 | £52–£688 |
| CAD | CA$30–CA$487 | CA$87–CA$1160 |
| EUR | €21–€336 | €60–€800 |
| CHF | CHF 24–CHF 386 | CHF 79–CHF 1056 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0031?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair U0031?
DIY replacement parts average $23–$363, while professional service averages $65–$864.

### Will resetting U0031 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

