# OBD-II U0027: Low Speed CAN Communication Bus (-) Shorted to Bus (+)

> **Quick Answer:** OBD-II fault code U0027 indicates Low Speed CAN Communication Bus (-) Shorted to Bus (+). Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$756.

- **URL:** https://faultcodes.org/automotive/obd2-u0027
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0027 describes the two wires of a low-speed CAN, (+) and (-), touching each other. On a high-speed bus such a short ends all traffic, but the fault-tolerant layer of ISO 11898-3 is built to ride it out. NXP's TJA1055 counts it as failure 7: the receive signal first sticks at dominant, then within about 0.3 to 1.6 ms the transceiver turns off its CAN-Low driver, leaves that wire with only a weak pull-up and carries on in single-wire mode. Comfort functions usually still work, though with less margin against interference, and differential operation resumes by itself once the short is cleared. No manufacturer documents U0027 publicly; a single-wire bus like GM's low-speed GMLAN cannot have this fault at all. Squeezed harness sections and wet splices are the likely spots; compare the high-speed sibling U0009.

## Common Symptoms
- Comfort network keeps running, sometimes with dropouts
- Higher sensitivity to electrical interference
- Code stored in several body modules at once

## Most Likely Root Causes
- Harness crushed so that both bus wires make contact
- Water in a splice or connector bridging the two wires
- Damaged transceiver bridging its two bus pins

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Low Speed Can Wiring.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Low Speed Can Wiring.
5. Clear fault memory and run a verification cycle to confirm U0027 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$318 | $54–$756 |
| GBP | £15–£250 | £43–£602 |
| CAD | CA$26–CA$426 | CA$73–CA$1015 |
| EUR | €18–€294 | €50–€700 |
| CHF | CHF 21–CHF 338 | CHF 66–CHF 924 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0027?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair U0027?
DIY replacement parts average $19–$318, while professional service averages $54–$756.

### Will resetting U0027 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

