# OBD-II U0026: Low Speed CAN Communication Bus (-) High

> **Quick Answer:** OBD-II fault code U0026 indicates Low Speed CAN Communication Bus (-) High. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$648.

- **URL:** https://faultcodes.org/automotive/obd2-u0026
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0026 means CAN-Low, the (-) line of a two-wire low-speed CAN, is held too high. Since this wire already sits near 5 V at rest in an ISO 11898-3 network, the outcome depends on where the short goes. Against the 5 V supply (failure 6a in NXP's TJA1055) the transceiver stays in differential mode with normal drivers and termination. Against battery voltage (failure 6) its comparator trips after roughly 0.3 to 1.6 ms, the CAN-Low driver is switched off, the termination becomes a weak pull-up and reception continues over CAN-High alone. Either way the bus normally survives, which is why the code is often found without a clear complaint. No manufacturer documents U0026 publicly, and the GM low-speed GMLAN gets by with one conductor. Look for chafing against a feed wire or water in a connector.

## Common Symptoms
- Often no noticeable effect
- Occasional comfort function dropouts when the bus runs on one wire

## Most Likely Root Causes
- CAN-Low chafed against a battery or ignition feed
- Moisture in a connector linking CAN-Low to a supply pin
- Faulty transceiver driving CAN-Low to its supply

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Low Speed Can Wiring.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Low Speed Can Wiring.
5. Clear fault memory and run a verification cycle to confirm U0026 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$272 | $54–$648 |
| GBP | £15–£214 | £43–£516 |
| CAD | CA$26–CA$365 | CA$73–CA$870 |
| EUR | €18–€252 | €50–€600 |
| CHF | CHF 21–CHF 290 | CHF 66–CHF 792 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0026?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair U0026?
DIY replacement parts average $19–$272, while professional service averages $54–$648.

### Will resetting U0026 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

