# OBD-II U0025: Low Speed CAN Communication Bus (-) Low

> **Quick Answer:** OBD-II fault code U0025 indicates Low Speed CAN Communication Bus (-) Low. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$648.

- **URL:** https://faultcodes.org/automotive/obd2-u0025
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0025 flags CAN-Low pulled toward ground on a low-speed CAN with two conductors. In the fault-tolerant physical layer of ISO 11898-3 CAN-Low idles near 5 V, so a ground short forces it into its dominant state for good. NXP's TJA1055 (failure 4) first sees a permanently dominant receive signal; after about 0.3 to 1.6 ms it switches the CAN-Low driver off, changes that line's termination to a weak pull-up and continues in single-wire mode on CAN-High. Messages keep flowing, but with weaker immunity to interference, so sporadic dropouts of comfort functions are possible. The transceiver goes back to differential mode by itself once the short is gone. No manufacturer documents U0025 publicly; GM's one-conductor bus has no (-) side at all. Resistance from CAN-Low to ground near 0 Ω with the battery off confirms the fault.

## Common Symptoms
- Comfort functions work but drop out now and then
- Body modules store the code repeatedly

## Most Likely Root Causes
- CAN-Low insulation damaged and touching body ground
- Harness trapped by a panel, bracket or seat mechanism
- Module transceiver internally shorting CAN-Low to ground

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Low Speed Can Wiring.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Low Speed Can Wiring.
5. Clear fault memory and run a verification cycle to confirm U0025 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$272 | $54–$648 |
| GBP | £15–£214 | £43–£516 |
| CAD | CA$26–CA$365 | CA$73–CA$870 |
| EUR | €18–€252 | €50–€600 |
| CHF | CHF 21–CHF 290 | CHF 66–CHF 792 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0025?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair U0025?
DIY replacement parts average $19–$272, while professional service averages $54–$648.

### Will resetting U0025 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

