# OBD-II U0024: Low Speed CAN Communication Bus (-) Open

> **Quick Answer:** OBD-II fault code U0024 indicates Low Speed CAN Communication Bus (-) Open. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$540.

- **URL:** https://faultcodes.org/automotive/obd2-u0024
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0024 reports an interruption of the (-) line, CAN-Low, of a two-wire low-speed CAN. Under the ISO 11898-3 fault-tolerant scheme this wire idles near 5 V and is pulled toward ground for dominant bits. NXP's TJA1055 counts a broken CAN-Low as failure 2, keeps drivers and termination as they are and goes on receiving differentially; it can flag the break only when the gap separates transmitter and receiver, which makes its error output flicker. Because the network keeps running, the fault often surfaces only as a stored code in modules beyond the break. Places where wires flex, such as door or tailgate transitions, are obvious suspects. The single-wire GM low-speed GMLAN has no (-) line, so the code has no meaning there. No manufacturer documents U0024 publicly.

## Common Symptoms
- Typically no symptom, code found during a scan
- Comfort functions behind the break react sluggishly or sporadically

## Most Likely Root Causes
- CAN-Low wire broken in a door or tailgate harness
- CAN-Low terminal backed out of its connector
- Corroded CAN-Low contact after water entry

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Low Speed Can Wiring.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Low Speed Can Wiring.
5. Clear fault memory and run a verification cycle to confirm U0024 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$227 | $54–$540 |
| GBP | £15–£179 | £43–£430 |
| CAD | CA$26–CA$305 | CA$73–CA$725 |
| EUR | €18–€210 | €50–€500 |
| CHF | CHF 21–CHF 241 | CHF 66–CHF 660 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0024?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair U0024?
DIY replacement parts average $19–$227, while professional service averages $54–$540.

### Will resetting U0024 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

