# OBD-II U0023: Low Speed CAN Communication Bus (+) High

> **Quick Answer:** OBD-II fault code U0023 indicates Low Speed CAN Communication Bus (+) High. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$648.

- **URL:** https://faultcodes.org/automotive/obd2-u0023
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0023 means CAN-High, the (+) conductor of a dual-line low-speed CAN, sits too high, typically shorted to battery voltage or a 5 V supply. Under ISO 11898-3 this pins the line at a level the receivers read as permanently dominant. NXP's TJA1055 handles it as failure 3 or 3a in two steps: once an initial delay expires it falls back to single-wire operation, and if the line is still too high it moves over to CAN-Low, switches its CAN-High driver off and weakens that line's termination; detection takes about 1.6 to 8 ms. Traffic continues on one wire, though electromagnetic robustness is worse in that mode. No manufacturer documents U0023 publicly; GM's low-speed GMLAN, being a single conductor, offers no (+)/(-) pair. CAN-High measuring near battery voltage against ground instead of its resting level close to 0 V points to the short.

## Common Symptoms
- Comfort functions mostly still work, occasional glitches
- Increased sensitivity to interference, e.g. with radio transmitters nearby
- Code stored in several body modules

## Most Likely Root Causes
- CAN-High chafed against a battery feed or ignition wire
- Water in a connector bridging CAN-High to a supply pin
- Retrofitted accessory tapped into the wrong wire

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Low Speed Can Wiring.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Low Speed Can Wiring.
5. Clear fault memory and run a verification cycle to confirm U0023 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$272 | $54–$648 |
| GBP | £15–£214 | £43–£516 |
| CAD | CA$26–CA$365 | CA$73–CA$870 |
| EUR | €18–€252 | €50–€600 |
| CHF | CHF 21–CHF 290 | CHF 66–CHF 792 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0023?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair U0023?
DIY replacement parts average $19–$272, while professional service averages $54–$648.

### Will resetting U0023 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

