# OBD-II U0022: Low Speed CAN Communication Bus (+) Low

> **Quick Answer:** OBD-II fault code U0022 indicates Low Speed CAN Communication Bus (+) Low. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$648.

- **URL:** https://faultcodes.org/automotive/obd2-u0022
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0022 indicates a ground short on CAN-High, the positive conductor of a dual-wire low-speed CAN. In the fault-tolerant design of ISO 11898-3, where CAN-High idles at about 0 V and only rises for dominant bits, a ground short simply takes that rise away. NXP's TJA1055 lists CAN-High to ground as failure 5 and keeps transmitting and receiving differentially, since its receiver threshold is chosen so that reception stays correct in this case as well. The network therefore keeps working, and the driver often notices nothing apart from the stored code. On GM's single-wire low-speed GMLAN the (+)/(-) naming does not fit. No manufacturer documents U0022 publicly. With the battery disconnected, a reading near zero ohms from CAN-High to ground confirms the short; trim screws and seat rails are typical culprits.

## Common Symptoms
- Frequently no symptom besides the stored code
- Rare sporadic comfort function faults

## Most Likely Root Causes
- CAN-High insulation chafed through against body ground
- Wire pierced by a trim screw or trapped under a seat rail
- Internal transceiver fault pulling CAN-High low

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Low Speed Can Wiring.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Low Speed Can Wiring.
5. Clear fault memory and run a verification cycle to confirm U0022 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$272 | $54–$648 |
| GBP | £15–£214 | £43–£516 |
| CAD | CA$26–CA$365 | CA$73–CA$870 |
| EUR | €18–€252 | €50–€600 |
| CHF | CHF 21–CHF 290 | CHF 66–CHF 792 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0022?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair U0022?
DIY replacement parts average $19–$272, while professional service averages $54–$648.

### Will resetting U0022 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

