# OBD-II U0010: Medium Speed CAN Communication Bus

> **Quick Answer:** OBD-II fault code U0010 indicates Medium Speed CAN Communication Bus. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $65–$972.

- **URL:** https://faultcodes.org/automotive/obd2-u0010
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0010 is the general fault code for the medium-speed CAN, a slower two-wire network that several makers run next to the fast powertrain bus. Saab/GM documents it as mid-speed GMLAN with (+) and (-) wires and a terminating resistor across them, Ford as MS-CAN; on the F-Super Duty an unplugged connector C408 interrupts it and takes climate control, front control panel and headlamp logic down with it. Code-specific users are Volvo and Mack: their aftertreatment module logs U0010-88 together with U0001-88 when chafed wiring cuts communication, with MIL and possible derate. Ford, by contrast, tells Transit technicians to ignore a U0010 in the rear camera module after BCM programming if the camera works. On passenger cars a fault here mainly costs comfort functions, not driveability.

## Common Symptoms
- Climate control, lighting or infotainment functions inoperative
- Several body modules unreachable with the scan tool
- On heavy trucks MIL and engine derate possible

## Most Likely Root Causes
- Connector in the medium-speed network unplugged or not seated
- Harness chafed or wet at doors, tailgate or body mounts
- Residual code after module replacement or programming

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Can Bus Wiring.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Can Bus Wiring.
5. Clear fault memory and run a verification cycle to confirm U0010 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$408 | $65–$972 |
| GBP | £18–£321 | £52–£774 |
| CAD | CA$30–CA$548 | CA$87–CA$1305 |
| EUR | €21–€378 | €60–€900 |
| CHF | CHF 24–CHF 435 | CHF 79–CHF 1188 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0010?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair U0010?
DIY replacement parts average $23–$408, while professional service averages $65–$972.

### Will resetting U0010 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

