# OBD-II U0009: High Speed CAN Communication Bus (-) Shorted to Bus (+)

> **Quick Answer:** OBD-II fault code U0009 indicates High Speed CAN Communication Bus (-) Shorted to Bus (+). Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$1296.

- **URL:** https://faultcodes.org/automotive/obd2-u0009
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0009 describes CAN-Low and CAN-High of the high-speed bus being shorted to each other. The voltage difference between them then stays at zero, which every receiver interprets as recessive, so a dominant bit can never form; onsemi's tests show transmission stopping entirely and controllers running into bus-off. According to NXP, transceiver bus diagnosis cannot detect this short, so a module infers it from protocol errors instead. No manufacturer documents U0009 publicly. With the battery disconnected, the resistance between both lines reads close to zero ohms instead of the usual 60. Likely sources are a crushed harness section, water inside a splice or connector, or a damaged transceiver in one module bridging its two bus pins. Unplugging modules one by one narrows the location down.

## Common Symptoms
- No communication on the high-speed network at all
- Numerous warnings, fallback modes, possibly no start
- Scan tool reaches only modules on other networks

## Most Likely Root Causes
- Bus pair crushed so that both conductors touch
- Water or corrosion bridging CAN-High and CAN-Low in a splice or connector
- Failed transceiver shorting both bus pins inside a module

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Can High Wire.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Can High Wire.
5. Clear fault memory and run a verification cycle to confirm U0009 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$544 | $86–$1296 |
| GBP | £24–£428 | £69–£1032 |
| CAD | CA$41–CA$731 | CA$116–CA$1740 |
| EUR | €28–€504 | €80–€1200 |
| CHF | CHF 32–CHF 580 | CHF 106–CHF 1584 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0009?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair U0009?
DIY replacement parts average $30–$544, while professional service averages $86–$1296.

### Will resetting U0009 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

