# OBD-II U0008: High Speed CAN Communication Bus (-) High

> **Quick Answer:** OBD-II fault code U0008 indicates High Speed CAN Communication Bus (-) High. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$1080.

- **URL:** https://faultcodes.org/automotive/obd2-u0008
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0008 means CAN-Low, the (-) wire of the high-speed CAN, is forced too high, typically through contact with the 12 V system or another supply rail. This fault blocks the bus: CAN-Low can no longer be driven down, no dominant state develops, and both onsemi and NXP found that transmission becomes impossible. Senders accumulate errors until they reach bus-off, so U0001 and lost-communication codes nearly always appear alongside, and engine, transmission or brake electronics may switch to stored default values. No manufacturer documents U0008 publicly. With ignition on, CAN-Low reading close to battery voltage instead of about 1.5 to 2.5 V confirms it; the contact point is usually where the bus pair runs beside a supply feed, for example after an accessory installation.

## Common Symptoms
- Total communication loss on the high-speed network
- Many warning lamps, possible no-start
- Scan tool cannot reach powertrain modules

## Most Likely Root Causes
- CAN-Low chafed against a battery or ignition supply wire
- Retrofit wiring tapped into the bus pair by mistake
- Bent pin or moisture linking CAN-Low to a supply contact

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Can Low Wire.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Can Low Wire.
5. Clear fault memory and run a verification cycle to confirm U0008 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$454 | $86–$1080 |
| GBP | £24–£357 | £69–£860 |
| CAD | CA$41–CA$609 | CA$116–CA$1450 |
| EUR | €28–€420 | €80–€1000 |
| CHF | CHF 32–CHF 483 | CHF 106–CHF 1320 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0008?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair U0008?
DIY replacement parts average $30–$454, while professional service averages $86–$1080.

### Will resetting U0008 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

