# OBD-II U0006: High Speed CAN Communication Bus (-) Open

> **Quick Answer:** OBD-II fault code U0006 indicates High Speed CAN Communication Bus (-) Open. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$864.

- **URL:** https://faultcodes.org/automotive/obd2-u0006
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0006 points to an interrupted CAN-Low conductor, i.e. the (-) line on the high-speed network. That line rests near 2.5 V and sinks by about a volt whenever a dominant bit is sent. Nodes isolated by the break no longer receive a usable differential signal from the rest of the network, while the modules still joined on both wires can go on exchanging data. A line interruption is outside what common high-speed transceivers can diagnose themselves (NXP), so the code relies on module-specific checks such as missing acknowledgements. No manufacturer documents U0006 publicly. Frequent findings are a conductor fractured at a door or tailgate hinge, a backed-out terminal or a corroded splice. With the battery disconnected, a check across the two lines often shows about twice the normal 60 ohms when the break separates one of the terminators.

## Common Symptoms
- Part of the modules unreachable, others still respond
- Warnings from the affected systems, sometimes only when moving doors or harness

## Most Likely Root Causes
- CAN-Low conductor fractured at a hinge or flex point
- Corroded splice or connector in the CAN-Low path
- CAN-Low terminal backed out after work on the harness

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Can Low Wire.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Can Low Wire.
5. Clear fault memory and run a verification cycle to confirm U0006 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$363 | $86–$864 |
| GBP | £24–£286 | £69–£688 |
| CAD | CA$41–CA$487 | CA$116–CA$1160 |
| EUR | €28–€336 | €80–€800 |
| CHF | CHF 32–CHF 386 | CHF 106–CHF 1056 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0006?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair U0006?
DIY replacement parts average $30–$363, while professional service averages $86–$864.

### Will resetting U0006 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

