# OBD-II U0004: High Speed CAN Communication Bus (+) Low

> **Quick Answer:** OBD-II fault code U0004 indicates High Speed CAN Communication Bus (+) Low. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$1080.

- **URL:** https://faultcodes.org/automotive/obd2-u0004
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0004 means the (+) wire of the high-speed CAN, CAN-High, is dragged below its valid range, usually by a short to ground. This is one of the faults the physical layer cannot absorb: a sending node is unable to produce a dominant bit, every frame attempt fails, the error counters rise and the controllers end up bus-off, as onsemi's bench measurements show. Transceivers with bus diagnosis, NXP's TJA1043 for example, recognise this short up to roughly 50 ohms. Typically all powertrain and chassis modules on the network fall silent at the same moment, accompanied by U0001 and a string of lost-communication codes. No manufacturer documents U0004 publicly; an FCA bulletin describes the same picture under U0001, caused by a harness pinched beneath a console bolt.

## Common Symptoms
- Network-wide communication loss, scan tool cannot connect
- Engine, gearbox, ABS and steering warnings together
- Vehicle may not start or run in limp mode

## Most Likely Root Causes
- CAN-High insulation damaged and touching body ground
- Harness clamped by a screw, bracket or seat rail
- Defective transceiver in one module pulling CAN-High down

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Can High Wire.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Can High Wire.
5. Clear fault memory and run a verification cycle to confirm U0004 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$454 | $86–$1080 |
| GBP | £24–£357 | £69–£860 |
| CAD | CA$41–CA$609 | CA$116–CA$1450 |
| EUR | €28–€420 | €80–€1000 |
| CHF | CHF 32–CHF 483 | CHF 106–CHF 1320 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0004?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair U0004?
DIY replacement parts average $30–$454, while professional service averages $86–$1080.

### Will resetting U0004 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

