# OBD-II P0729: Gear 6 Incorrect Ratio

> **Quick Answer:** OBD-II fault code P0729 indicates Gear 6 Incorrect Ratio. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $162–$3780.

- **URL:** https://faultcodes.org/automotive/obd2-p0729
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Transmission & Drivetrain
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The transmission module divides input (turbine) speed by output speed and compares the result with the ratio of the commanded gear; a deviation means slip – a clutch or brake not holding, too little pressure – or a wrong gear. Thresholds: Ford more than 30 rpm off for 1.8 s three times (diesel 2023: over 20 % for 12 s), GM's 2006 tables and the Allison 1000 converter slip of 200–230 rpm for 2.25 s after one trip, Saab's Aisin boxes over 20 % twelve times without MIL. P0729 concerns sixth gear. Saab's Aisin six-speed also checks whether the actual ratio matches fourth or fifth – the sixth gear clutch is not holding and the box drops into another gear. Ford stores it only if the fault does not fit a particular solenoid (otherwise P0751 ff). On GM manual transmissions (LT4) it checks the gear position sensor instead.

## Common Symptoms
- Slipping or flare in sixth gear, engine speed higher than expected
- Harsh or delayed shifts
- Limp mode (Aisin: second gear and reverse only), transmission warning
- Check engine light depending on manufacturer

## Most Likely Root Causes
- Fluid level too low or fluid worn or contaminated
- Clutch for sixth gear worn (linings, piston seal)
- Sticking shift or pressure valve, leaking valve body gasket, blocked passages
- GM manual transmissions only: gear position sensor faulty or not learned

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Transmission Clutches.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Transmission Clutches.
5. Clear fault memory and run a verification cycle to confirm P0729 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $57–$1588 | $162–$3780 |
| GBP | £45–£1250 | £129–£3010 |
| CAD | CA$77–CA$2132 | CA$218–CA$5075 |
| EUR | €53–€1470 | €150–€3500 |
| CHF | CHF 61–CHF 1690 | CHF 198–CHF 4620 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0729?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0729?
DIY replacement parts average $57–$1588, while professional service averages $162–$3780.

### Will resetting P0729 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

