# OBD-II P0727: Engine Speed Input Circuit No Signal

> **Quick Answer:** OBD-II fault code P0727 indicates Engine Speed Input Circuit No Signal. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $65–$432.

- **URL:** https://faultcodes.org/automotive/obd2-p0727
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Transmission & Drivetrain
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The transmission module needs engine speed for converter slip, shift quality and to check the turbine speed. Today it almost always arrives over CAN from the engine module with a validity flag; only GM's 2007 Allison 1000 tables show a separate engine speed sensor read by the transmission module. P0727 means the engine speed signal is missing although the transmission is turning. The Allison 1000 flags under 61 rpm for 4 s with turbine speed of 400 rpm or more, after two trips; Saab's 9-3 of 2000 input speed above 2000 rpm for more than 5 s without engine speed; a 2006 GM table the CAN engine speed failing to answer. The module then works without converter slip information, usually locks out the converter clutch and may enter limp mode.

## Common Symptoms
- Transmission warning lamp, possibly check engine light
- Torque converter clutch locked out
- Harsh shifts or limp mode
- Often an engine code (crankshaft sensor) as well

## Most Likely Root Causes
- Engine speed wire or connector open, or own sensor (Allison) faulty
- CAN communication between engine and transmission module disturbed
- Crankshaft sensor fault in the engine module
- Transmission module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Engine Speed Signal.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Engine Speed Signal.
5. Clear fault memory and run a verification cycle to confirm P0727 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$181 | $65–$432 |
| GBP | £18–£143 | £52–£344 |
| CAD | CA$30–CA$244 | CA$87–CA$580 |
| EUR | €21–€168 | €60–€400 |
| CHF | CHF 24–CHF 193 | CHF 79–CHF 528 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0727?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0727?
DIY replacement parts average $23–$181, while professional service averages $65–$432.

### Will resetting P0727 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

