# OBD-II P0725: Engine Speed Input Circuit

> **Quick Answer:** OBD-II fault code P0725 indicates Engine Speed Input Circuit. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $54–$432.

- **URL:** https://faultcodes.org/automotive/obd2-p0725
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Transmission & Drivetrain
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The transmission module needs engine speed for converter slip, shift quality and to check the turbine speed. Today it almost always arrives over CAN from the engine module with a validity flag; only GM's 2007 Allison 1000 tables show a separate engine speed sensor read by the transmission module. P0725 is the general fault of this input; with CAN it means the engine module marks its speed value as invalid. Saab's Aisin transmissions and a 2006 GM table set it after about 4 s, the GM table with immediate MIL. A Saab bulletin notes that behind P0725 there is always a crankshaft or camshaft sensor code in the engine module (P0016, P0335–P0339) – so read the engine module first. Limp mode follows; a completely missing CAN message is U0100.

## Common Symptoms
- Transmission warning lamp, possibly check engine light
- Torque converter clutch locked out
- Harsh shifts or limp mode
- Often an engine code (crankshaft sensor) as well

## Most Likely Root Causes
- Crankshaft or camshaft sensor fault in the engine module (speed invalid there)
- CAN fault between engine and transmission module (wiring, termination, connector)
- Engine module software or fault
- Transmission module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Engine Speed Signal.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Engine Speed Signal.
5. Clear fault memory and run a verification cycle to confirm P0725 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$181 | $54–$432 |
| GBP | £15–£143 | £43–£344 |
| CAD | CA$26–CA$244 | CA$73–CA$580 |
| EUR | €18–€168 | €50–€400 |
| CHF | CHF 21–CHF 193 | CHF 66–CHF 528 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0725?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0725?
DIY replacement parts average $19–$181, while professional service averages $54–$432.

### Will resetting P0725 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

